Free Shipping $49+
Factory Direct No Middleman
30-Day Returns
24/7 1-800-HEIMA-00
Washer door fails to latch and lock, preventing the wash cycle from starting.
Washer appears powered on but cycle will not initiate due to a failed door lock signal.
Washer halts unexpectedly during wash or spin because the lock switch loses continuity.
Door unlocks or pops open while the drum is spinning, creating a water leak hazard.
Washer repeatedly retries locking, extending cycle time or triggering a fault code.
💡 Pro Tip: Is Your Door Lock Switch the Problem?
Your part is likely the culprit if you notice any of the following:
⚠️ Washer door refuses to lock — cycle will not start at all
⚠️ Door unlocks or pops open mid-cycle during wash or spin
⚠️ Washer stops unexpectedly mid-cycle or runs longer than normal
⚠️ Control panel shows a door lock error code (dL, dS, or similar)
🛠 Quick Test: Set your multimeter to continuity mode. With the washer unplugged, probe the door lock switch terminals. A healthy switch shows continuity when the door is fully latched. No continuity = replace the switch. Also inspect the door strike and latch hook — a bent strike can fool you into replacing a good lock.
📦 What's in the Box
✅ 1× Door Lock Switch Assembly DC34-00028A (AC 120V / 16A, solenoid type)
We typically respond within 1 business day. Include your appliance model number for the fastest answer.
Disclaimer: Compatibility information, part numbers, and model fitment data on this page are sourced from manufacturer databases and third-party references. While we strive for accuracy, please verify your appliance model number before ordering. Heima is not responsible for errors or omissions in compatibility listings.
Reviews
There are no reviews yet.