5301EL1001A Dryer Heater Assembly Compatible with LG Kenmore, Replaces AP4438941 5301EL1001E 5301EL1001G AEG72910307 1377645

💡 Pro Tip: How to Confirm Your Heater Assembly Has Failed

Your part is likely the culprit if you notice any of the following:

⚠️ Dryer runs normally but produces no heat — drum spins, timer counts down, but clothes stay wet

⚠️ Clothes take 2–3 cycles to dry fully, or only feel warm instead of hot at exhaust

⚠️ Heat kicks on then cuts off mid-cycle intermittently — points to a failed coil or tripped thermal fuse on the assembly

⚠️ Visible break or burn in the heating coil wire, or the thermal fuse tests open (no continuity) on a multimeter

🔍 Diagnostic tip: Set your multimeter to resistance (Ω) mode. Disconnect the red wire and measure from the red terminal to the yellow terminal — a healthy element reads approximately 10 Ω. Then measure red to blue for another ~10 Ω. A reading of OL (open loop) confirms a blown element or fuse. Always inspect the high-limit thermostat (6931EL3003D) and cycling thermostat (6931EL3001E) at the same time — a failed thermostat is often what caused the element to burn out in the first place.