






Washer runs full cycle but detergent, bleach, or fabric softener remains in the dispenser cup — actuator motor has failed to open the correct chamber.
Control board detects a dispenser circuit fault and halts the cycle. Replacing the actuator clears the fault and restores normal operation.
Cleaning agents dispense inconsistently — sometimes released, sometimes not — indicating a worn actuator gear or intermittent electrical fault.
Machine locks the door, attempts to start, clicks, then shuts off with a dispenser-related error — classic sign of a seized or electrically shorted actuator.




💡 Pro Tip: How to Confirm Your Dispenser Actuator Has Failed
Your part is likely the culprit if you notice any of the following:
⚠️ Detergent, bleach, or fabric softener cup not dispensing during the wash cycle
⚠️ Washer displays F8 E2, F30, or similar dispenser-related error codes
⚠️ Intermittent or completely absent dispensing — softener left in cup after full cycle
⚠️ Washer clicks and shuts down shortly after starting a cycle
🔍 Diagnostic Tip: Lift the washer's top panel and visually inspect the actuator above the dispenser drawer. Audible clicking with no movement, or no click at all when the cycle starts, confirms actuator failure. Also check for detergent residue coating the connector pins — moisture from a loose drain hose above the drum can short the actuator and cause repeat failures.
📦 What's in the Box
✅ 1× W10352973 Washer Dispenser Actuator Switch (120V / 60Hz, off-white plastic & metal, direct replacement for WPW10352973)
We typically respond within 1 business day. Include your appliance model number for the fastest answer.
Disclaimer: Compatibility information, part numbers, and model fitment data on this page are sourced from manufacturer databases and third-party references. While we strive for accuracy, please verify your appliance model number before ordering. Heima is not responsible for errors or omissions in compatibility listings.
Reviews
There are no reviews yet.