Free Shipping $49+
Factory Direct No Middleman
30-Day Returns
24/7 1-800-HEIMA-00
Dishwasher starts a cycle but no water enters the tub, leaving the drum dry and dishes unwashed.
Water continuously enters the tub even when the dishwasher is off, or the tub fills beyond the normal level causing leaks onto the floor.
Dishwasher takes excessively long to fill or fills unevenly, resulting in poor wash performance and dirty dishes.
A loud buzzing or humming noise is heard during the fill stage of the cycle, indicating the solenoid is energizing but the valve is blocked or failed.
Water accumulates at the bottom of the dishwasher tub after the cycle completes, often caused by a dripping inlet valve slowly leaking water in.
💡 Pro Tip: How to Know Your Inlet Valve Has Failed
Your part is likely the culprit if you notice any of the following:
⚠️ Dishwasher won't fill with water at the start of a cycle
⚠️ Dishwasher overfills or water leaks into the tub when not in use
⚠️ Buzzing or humming noise during the fill stage with little or no water flow
⚠️ Water fills slowly or inconsistently, leaving dishes dirty
🔍 Diagnostic Trick: After a completed wash cycle, place a dry paper towel against the fill valve outlet port. If it gets wet, the valve's internal rubber seal has deteriorated and is slowly dripping — replace immediately to prevent standing water issues and motor damage.
📦 What's in the Box
✅ 1× Dishwasher Water Inlet Solenoid Valve with Mounting Bracket (120V / 60Hz, 4" × 2-5/8" × 2-3/8")
We typically respond within 1 business day. Include your appliance model number for the fastest answer.
Disclaimer: Compatibility information, part numbers, and model fitment data on this page are sourced from manufacturer databases and third-party references. While we strive for accuracy, please verify your appliance model number before ordering. Heima is not responsible for errors or omissions in compatibility listings.
Reviews
There are no reviews yet.