Free Shipping $49+
Factory Direct No Middleman
30-Day Returns
24/7 1-800-HEIMA-00
Washer does not take in water on any cycle setting (cold, warm, or hot) due to failed solenoid coil inside the valve.
Machine fills only with cold water; the hot-water solenoid port has lost continuity and no longer opens.
Tub keeps filling past the set level or fills when the machine is off because a solenoid is stuck in the open position.
Long fill cycles caused by a restricted or clogged valve that cannot be cleaned — only replacement resolves this.
Residual water drips into the tub between cycles or after power-off, indicating a valve that fails to fully close.
Water enters and exits the tub at the same time, often traced back to a valve that remains partially open during the drain phase.
💡 Pro Tip: Is Your Water Inlet Valve Failing?
Your part is likely the culprit if you notice any of the following:
⚠️ Washer won't fill at all on any setting (cold, warm, or hot)
⚠️ Only cold water fills — no hot water even with correct setting
⚠️ Washer fills and drains simultaneously during the cycle
⚠️ Tub overflows or won't stop filling after cycle ends
⚠️ Water drips or leaks into the tub when the washer is off
🔍 Quick Field Test: Unplug the washer the moment you observe the symptom. If the tub continues to fill with power disconnected, the inlet valve solenoid is stuck open and must be replaced — do not attempt to clean or rebuild it, replace the entire valve assembly.
📦 What's in the Box
✅ 1× Water Inlet Valve with Mounting Bracket (Part # 285805, valve body: blue or green)
We typically respond within 1 business day. Include your appliance model number for the fastest answer.
Disclaimer: Compatibility information, part numbers, and model fitment data on this page are sourced from manufacturer databases and third-party references. While we strive for accuracy, please verify your appliance model number before ordering. Heima is not responsible for errors or omissions in compatibility listings.
Reviews
There are no reviews yet.