



Heating element has failed open-circuit, so the heated dry cycle produces no heat — dishes remain wet at end of cycle.
Wash water stays cold; greasy residue and food particles remain on dishes because the element cannot reach sanitizing temperature.
Control board detects an abnormal heating circuit reading and flashes the Clean indicator light as a fault signal.
Unit halts during the wash or dry phase when the control board registers a heating timeout or open-element fault.
Water temperature never reaches the level needed to kill bacteria, leaving dishes unhygienic despite a full wash cycle.





💡 Pro Tip: Is Your Heating Element the Problem?
Your part is likely the culprit if you notice any of the following:
⚠️ Dishes come out wet or cool after a full heated-dry cycle
⚠️ Wash water never gets hot — greasy residue remains on dishes
⚠️ The "Clean" light on the control panel blinks repeatedly
⚠️ Dishwasher stops mid-cycle or displays a heating fault code
Use a multimeter to test continuity across the two element terminals. A good element reads 10–30 ohms. An open (infinite resistance) reading confirms the element has failed and must be replaced. After installing the new element, run an empty diagnostic cycle to allow the control board to calibrate to the new element's resistance.
📦 What's in the Box
✅ 1× Dishwasher Heating Element (115V / 1060W, approx. 16.5"L × 16"W, fine-thread posts)
✅ 2× Heater Fasteners (plastic, 7/16"-20 fine thread)
✅ 2× Rubber Washers (for watertight tub-floor seal)
We typically respond within 1 business day. Include your appliance model number for the fastest answer.
Disclaimer: Compatibility information, part numbers, and model fitment data on this page are sourced from manufacturer databases and third-party references. While we strive for accuracy, please verify your appliance model number before ordering. Heima is not responsible for errors or omissions in compatibility listings.
Reviews
There are no reviews yet.