Free Shipping $49+
Factory Direct No Middleman
30-Day Returns
24/7 1-800-HEIMA-00
Clears U6 and A6 fault codes triggered when the original valve fails to properly open or close, restoring normal cycle operation.
Dishwasher drawer starts a cycle but fills with little or no water; the failed solenoid cannot open to allow water flow.
Water trickles into the drawer when the machine is idle or the drawer overfills during a cycle due to a solenoid stuck open.
Machine takes unusually long to fill and emits a humming or buzzing sound from the valve area, indicating a partially failed solenoid.
Mid-cycle pauses or resets caused by erratic water level readings stemming from inconsistent valve operation.
💡 Pro Tip: How to Know Your Inlet Valve Has Failed
Your part is likely the culprit if you notice any of the following:
⚠️ Dishwasher displays a U6 or A6 error code at the start of or during a wash cycle
⚠️ Drawer fills with little or no water — cycle starts but no wash action occurs
⚠️ Drawer overfills or water continues to trickle in when the machine is off
⚠️ Visible water hammer, slow fill, or humming noise from the valve area under the unit
Diagnostic tip: With the machine powered off and water supply shut off, disconnect the valve harness and test each solenoid coil with a multimeter. A healthy 24V solenoid reads approximately 200–500 Ω. An open circuit (OL) or very low reading confirms valve failure.
📦 What's in the Box
✅ 1× Double Inlet Valve Assembly 529730 (24V, includes both solenoid coils and valve body)
We typically respond within 1 business day. Include your appliance model number for the fastest answer.
Disclaimer: Compatibility information, part numbers, and model fitment data on this page are sourced from manufacturer databases and third-party references. While we strive for accuracy, please verify your appliance model number before ordering. Heima is not responsible for errors or omissions in compatibility listings.
Reviews
There are no reviews yet.