How to Replace 3051162 Front Drawer Glide on Frigidaire Range — Step-by-Step

Your Frigidaire range drawer won't close properly anymore — it either sticks halfway or won't latch at all. That frustrating gap means you can't store pans properly, and every time you try to shut it, you're fighting with a warmer drawer that's supposed to glide smoothly. The culprit? A worn-out front drawer glide. This $10 part takes about 10 minutes to replace, and you don't need special tools or appliance repair experience.

What You Need Before Starting

This is one of the easiest appliance repairs you'll tackle. Here's what makes it simple:

• Phillips head screwdriver
• Your replacement 3051162 glide
• Maybe a flashlight if your kitchen lighting isn't great

Repair Time: Less than 15 minutes
Difficulty: Easy

Safety First

You don't need to unplug the range for this repair since you're only working on the drawer mechanism, not any electrical components. Just make sure the drawer is fully extended and supported so it doesn't fall on your foot while you're working underneath it.

Step 1: Pull the Drawer All the Way Out

Open your warmer drawer completely until it stops. Look underneath at the front — you'll see the glide mechanism that's either cracked or worn smooth. On most Frigidaire models like the FEF326ASF or FFEF3011LWA, the drawer lifts straight out once it's fully extended, though some have a release lever on each side you'll need to press.

Step 2: Remove the Old Glide

Flip the drawer over and locate the front glide — it's the plastic piece that rides along the track. You'll see two Phillips screws holding it in place. Remove these screws and pull the old glide off. Notice how the plastic is probably worn down or cracked where it makes contact with the metal track.

Step 3: Install the New 3051162 Glide

Line up your new glide in the exact same position as the old one. The mounting holes are pre-positioned, so it'll only fit one way. Thread in both screws but don't fully tighten them yet — leave them just slightly loose so you can adjust alignment if needed.

Step 4: Test Fit and Tighten

Slide the drawer back into the range about halfway. Does it glide smoothly without binding? If it catches, pull it back out and adjust the glide position slightly. Once it moves freely, pull the drawer out again and tighten both screws completely. Don't overtighten — plastic cracks easily.

Step 5: Final Test

Slide the drawer in and out several times through its full range of motion. It should close completely now without that annoying gap you've been dealing with. The glide should feel smooth and solid, not wobbly or rough.

Testing After Installation

Open and close the drawer 10-15 times to make sure everything's seated properly. Load it with a few pans — the weight shouldn't cause any binding or resistance. If you hear squeaking, that's normal for the first few uses as the plastic breaks in against the metal track.

Frequently Asked Questions

Will this glide fit my Kenmore range?

Yes — this part is sold under multiple brand names. It fits Frigidaire, Tappan, Kenmore, and Gibson ranges. It replaces part numbers AP2121517, PS434226, 3131687, and 3012698. Check your model number against the compatibility list, but it works on dozens of models including the CFEF312GSA and FEF355ASK series.

Do I need to replace both glides or just one?

Technically you can replace just the failed one, but if one glide has worn out, the other isn't far behind. They wear at the same rate. Replacing both now saves you from doing this job again in six months when the other side fails.

What if my drawer still won't close after replacing the glide?

Check the metal tracks on the range itself for damage or debris. Sometimes food spills or grease buildup on the tracks prevents smooth operation. Wipe them clean with a degreaser. Also verify you installed the glide in the correct orientation — the curved edge should face forward.