







Gas dryer drum spins normally but produces no heat — igniter glows but gas valve never opens because the faulty sensor fails to send the 'hot enough' signal.
Burner ignites for approximately 1 minute then the flame shuts off unexpectedly mid-cycle, causing clothes to remain damp after a full cycle.
Dryer requires two or more full cycles to dry a normal load because the burner intermittently fires and cuts out due to an intermittent sensor failure.
A weak or failing flame sensor does not reliably signal the gas valve to close, allowing trace amounts of gas to linger near the burner assembly.
💡 Pro Tip: Diagnosing a Faulty Radiant Flame Sensor
Your part is likely the culprit if you notice any of the following:
⚠️ Gas dryer runs but produces no heat — drum spins yet clothes stay wet
⚠️ Igniter glows but the burner flame never lights or stays lit only briefly (1–2 min) before going out
⚠️ Dryer takes excessively long to dry a normal load — two or more full cycles
⚠️ Faint gas smell near laundry room — sensor failing to close the valve promptly
🔍 Test it yourself: Set your multimeter to continuity mode and probe both terminals of the sensor at room temperature. A healthy sensor shows continuity (beep/zero ohms). No continuity = confirmed bad sensor. Also consider replacing the gas valve coil kit (279834) and igniter (279311) at the same time for a complete burner assembly service.
📦 What's in the Box
✅ 1× 338906 Dryer Radiant Flame Sensor (plastic/metal composite housing, 2-wire connector)
We typically respond within 1 business day. Include your appliance model number for the fastest answer.
Disclaimer: Compatibility information, part numbers, and model fitment data on this page are sourced from manufacturer databases and third-party references. While we strive for accuracy, please verify your appliance model number before ordering. Heima is not responsible for errors or omissions in compatibility listings.
Reviews
There are no reviews yet.