Free Shipping $49+
Factory Direct No Middleman
30-Day Returns
24/7 1-800-HEIMA-00
Washer fills with only one temperature or no water at all — failed solenoid coil inside the triple valve prevents proper water flow.
Tub overfills or continues to fill after reaching the set level due to a stuck-open solenoid in the inlet valve.
Wash cycle takes too long to fill or water trickles in unevenly because mineral deposits have clogged the valve screens or solenoids.
Warm cycle runs cold or hot — thermistor or one of the three coils has failed, preventing proper hot/cold blending.
Cracked valve body or loose fitting at the inlet port causes water to drip or spray behind the machine during fill cycles.
💡 Pro Tip: How to Tell Your Triple Water Valve Has Failed
Your part is likely the culprit if you notice any of the following:
⚠️ Washer fills with only cold water even when Warm or Hot cycle is selected
⚠️ Machine fills very slowly or stops filling mid-cycle
⚠️ Tub keeps filling with water after reaching the set level or won't stop filling
⚠️ Water leaking from the back of the machine near the inlet valve area
🛠️ Quick Test: Set a multimeter to Rx100. Probe each solenoid coil — a healthy coil reads 200–500 Ω. An open (OL) or shorted (0 Ω) reading confirms a failed solenoid. Always unplug before testing.
📦 What's in the Box
✅ 1× Triple Water Inlet Valve (3-Coil, 120V / 60Hz, with Thermistor) — replaces WH13X10026
We typically respond within 1 business day. Include your appliance model number for the fastest answer.
Disclaimer: Compatibility information, part numbers, and model fitment data on this page are sourced from manufacturer databases and third-party references. While we strive for accuracy, please verify your appliance model number before ordering. Heima is not responsible for errors or omissions in compatibility listings.
Reviews
There are no reviews yet.