Free Shipping $49+
Factory Direct No Middleman
30-Day Returns
24/7 1-800-HEIMA-00
The solenoid coil inside the valve burns out or the inlet screen clogs, starving the tub of water and triggering LF error codes.
A stuck-open solenoid allows water to keep entering the tub even when the machine is off, causing overflow through dispensers or out from under the lid.
Cracked valve body or failed internal seal causes water to drip or stream onto the floor behind or beneath the machine.
A failed hot or cold solenoid prevents the valve from blending water correctly, resulting in all-hot or all-cold wash cycles regardless of the selected setting.
Excessive water pressure through a defective solenoid port floods the bleach or fabric softener dispenser, spilling water into the drum and onto the floor.
💡 Pro Tip: Is Your Water Inlet Valve the Problem?
Your part is likely the culprit if you notice any of the following:
⚠️ Washer fills very slowly or triggers an LF (Long Fill) error code
⚠️ Water continues dripping into the tub when the machine is off
⚠️ Washer overflows through the detergent or bleach dispenser
⚠️ Leaking water pooling behind or under the washer
🔍 Quick Check: Turn off both water supply hoses and run a short cycle. If the tub still fills (even slowly), the valve solenoid is stuck open and the valve must be replaced — do NOT attempt to clean it, as cleaning increases the risk of future failure.
📦 What's in the Box
✅ 1× W10853723 Washer Water Inlet & Dispenser Valve Assembly (dual-solenoid, top-load)
We typically respond within 1 business day. Include your appliance model number for the fastest answer.
Disclaimer: Compatibility information, part numbers, and model fitment data on this page are sourced from manufacturer databases and third-party references. While we strive for accuracy, please verify your appliance model number before ordering. Heima is not responsible for errors or omissions in compatibility listings.
Reviews
There are no reviews yet.