Free Shipping $49+
Factory Direct No Middleman
30-Day Returns
24/7 1-800-HEIMA-00
Washer leaves standing water in the drum at the end of the cycle — the pump motor has failed to expel wastewater through the drain hose.
Control board detects drain taking too long; replacing the pump clears this fault after ruling out a clogged coin trap or kinked drain hose.
Worn impeller bearings or foreign objects lodged in the pump volute cause rattling, grinding, or continuous humming during the drain phase.
Cracked pump housing or deteriorated mating gasket allows water to seep from the front or bottom of the washer during or after the wash cycle.
Washer pauses mid-cycle and will not advance to spin because the pump cannot clear water fast enough to satisfy the pressure sensor threshold.
💡 Pro Tip: How to Diagnose a Failed Drain Pump
Your part is likely the culprit if you notice any of the following:
⚠️ Washer displays F9 E1, E01 F09, or E01 F03 error codes
⚠️ Standing water remains in the drum after the cycle ends
⚠️ Loud grinding, humming, or rattling noise during the drain phase
⚠️ Water leaking from the front or bottom of the washer near the pump housing
Before replacing, check the pump filter / coin trap for debris blockage. If the filter is clear and error codes persist, test the pump motor windings with a multimeter for continuity. No continuity = pump failure confirmed. Always unplug the washer before any inspection.
📦 What's in the Box
✅ 1× Washer Drain Pump Assembly (120V / 60Hz / 0.95A) — pump sold individually, wire harness not included
We typically respond within 1 business day. Include your appliance model number for the fastest answer.
Disclaimer: Compatibility information, part numbers, and model fitment data on this page are sourced from manufacturer databases and third-party references. While we strive for accuracy, please verify your appliance model number before ordering. Heima is not responsible for errors or omissions in compatibility listings.
Reviews
There are no reviews yet.