Free Shipping $49+
Factory Direct No Middleman
30-Day Returns
24/7 1-800-HEIMA-00
Oven heats more than 50°F above or below the set temperature, causing overcooked or undercooked food.
Oven does not reach temperature or stops heating mid-cycle due to an open-circuit sensor sending no signal to the control board.
Control panel displays fault codes indicating oven over-temperature or sensor circuit failure. Replacing the sensor clears these codes.
Oven continues heating beyond the set temperature because a shorted sensor sends a falsely cold reading to the control board.
Erratic on/off cycling during bake or broil due to unstable resistance readings from a degraded temperature sensor.
💡 Pro Tip: Is Your Oven Sensor the Problem?
Your part is likely the culprit if you notice any of the following:
⚠️ Oven temperature is off by more than 50°F from the set temperature
⚠️ Oven over- or under-cooks food even at familiar settings
⚠️ Error codes F2, F3E2, or F6E1 appear on the control panel display
⚠️ Oven cycles on and off rapidly or does not heat at all
🔍 Quick Test: Set your multimeter to resistance (Ω) mode. Disconnect the sensor harness and probe both terminals. At room temperature (~75°F), a healthy sensor reads approximately 1,080–1,100Ω. An open circuit (OL/∞) or short (0Ω) confirms the sensor is faulty and must be replaced.
📦 What's in the Box
✅ 1× Oven Temperature Sensor Probe Assembly with wiring harness connector (fits W10181986 / WPW10181986 applications)
We typically respond within 1 business day. Include your appliance model number for the fastest answer.
Disclaimer: Compatibility information, part numbers, and model fitment data on this page are sourced from manufacturer databases and third-party references. While we strive for accuracy, please verify your appliance model number before ordering. Heima is not responsible for errors or omissions in compatibility listings.
Reviews
There are no reviews yet.