Samsung Electric Range Dual Radiant Surface Element Parts — Models & Compatibility

Your Samsung slide-in range's dual radiant surface element delivers two cooking zones in one burner — typically a 6-inch outer ring and a 9-inch expandable zone. When it fails, you'll notice uneven heating, one zone not working while the other does, or complete failure to heat. The DG47-00063A is the OEM replacement that fits Samsung's premium slide-in models from the NE58F and NE58K series.

Is This the Right Part for Your Model?

Check your model number on the label inside the oven door frame or along the front edge when you open the door. This dual element specifically fits Samsung's high-end slide-in ranges including the NE58F9500SS and NE58K9430SS series. You'll know it's compatible if your range has a dual-zone burner where you can select either the inner or outer heating ring independently.

About This Replacement Part

The DG47-00063A dual radiant element is a precision component that uses embedded heating coils beneath a ceramic glass cooktop. Unlike single-zone elements, this part contains two separate circuits controlled by independent relays, allowing you to switch between 6-inch and 9-inch cooking diameters. Samsung designed this element for their slide-in models with touch controls and seamless glass surfaces. The element mounts from underneath the cooktop, requiring you to lift the entire glass surface to access the mounting hardware — a job that demands careful handling since the glass is both heavy and fragile.

Compatible Samsung Range Models

This dual radiant element works with these Samsung electric range model numbers:

• NE58F9500SS/AA-02, NE58F9500SS/AA-03, NE58F9500SS/AA-04
• NE58F9500SS/AA-05, NE58F9500SS/AA-06, NE58F9500SS/AA-07
• NE58K9430SS/AA-00, NE58K9430SS/AA-01
• NE58K9500SG/AA-00, NE58K9500SG/AA-01, NE58K9500SG/AA-02

Note: The suffix after the slash indicates the production series. All listed series use the identical DG47-00063A element assembly.

Installation Considerations

Replacing this element isn't a simple plug-and-play job. You'll need to disconnect power at the breaker, remove the cooktop retaining screws around the perimeter, carefully lift the glass surface (usually 30-40 pounds), then disconnect the wire harness and unscrew the element bracket. The wire connectors use high-temperature ceramic terminals — inspect them for any burn marks or brittleness before connecting the new element. If you're uncomfortable working with 240V appliances or handling heavy glass, this is one to leave to a pro.

Why This Part Fails

Dual elements fail when one heating circuit develops a break in the coil, often from repeated thermal expansion and contraction. You might find the inner zone works but the outer doesn't, or vice versa. Sometimes the element develops a short to ground, which trips your breaker every time you select that burner. Spills that seep through the glass-to-element seal can also corrode the connection terminals over time, creating intermittent heating problems that progressively worsen.

Order Your Samsung Surface Element

The DG47-00063A dual radiant element is available for $206.99 with shipping to your door. Verify your model number against the compatibility list above before ordering — Samsung used different elements for their freestanding models versus slide-in models, and they're not interchangeable despite looking similar.