Samsung Washer Drum Spider Flange Shaft Assembly Parts — Models & Compatibility

The drum spider assembly is the critical hub that connects your Samsung washer's stainless steel drum to the drive shaft — when it fails, you'll hear grinding metal sounds or see the drum wobbling during spin cycles. This DC97-14370E replacement fits over 100 Samsung front-load washer and washer-dryer combo models, superseding older part numbers DC97-14370H, DC97-14370B, and DC97-14370D. If your washer has started making loud banging noises during spin or the drum moves excessively side-to-side, this assembly is likely the culprit.

Is This the Right Part for Your Model?

Your Samsung model number is typically located on a sticker inside the door frame or on the back panel. This drum spider assembly is specifically engineered for Samsung WD-series combo units and select front-load washers manufactured between 2015-2020. Compatible models include WD10J6410AW, WD80K5410OW, WD90J6A10AW, and dozens more — check the complete compatibility list below to verify your exact model number matches.

About This Replacement Part

The drum spider flange is a heavy-duty aluminum casting that anchors the stainless drum to the bearing assembly and drive shaft. Samsung's design uses a multi-spoke configuration that distributes the load during high-speed spin cycles — this part typically fails after 5-7 years when bearing wear causes misalignment, or when water intrusion corrodes the aluminum alloy. The DC97-14370E assembly includes the complete flange shaft with integrated mounting holes for the drum's mounting bolts. This is a direct OEM-spec replacement that restores factory balance and eliminates the vibration and noise caused by a worn or cracked spider.

Why This Part Fails

Spider assemblies crack or corrode when the drum bearing seal fails and allows water to seep into the bearing housing. Over time, moisture reacts with the aluminum casting, causing corrosion that weakens the spoke structure. You'll notice this as rust-colored residue on clothing, excessive vibration during spin, or a loud grinding sound that gets worse over time. The DC97-14370E uses an improved corrosion-resistant coating compared to earlier versions, but bearing seal integrity remains critical to long-term durability.

Installation Considerations

Replacing the drum spider requires complete disassembly of the wash tub — you'll need to remove the front panel, detach the door boot seal, disconnect the tub springs and shock absorbers, and split the tub halves to access the spider assembly. Most techs replace the bearing and seal (DC97-16350A) simultaneously since the tub is already apart. Budget 3-4 hours for a first-time repair, and note that some models use non-serviceable tub assemblies where the spider cannot be replaced separately — always verify your specific model's serviceability before ordering parts.

Compatible Model List

This DC97-14370E drum spider assembly has been verified compatible with the following Samsung washer and washer-dryer combo models. If your model number isn't listed here but starts with WD, check the full compatibility chart or contact our parts team for verification.