Whirlpool Refrigerator Condenser Fan Motor Parts — Models & Compatibility

If your Whirlpool refrigerator is running constantly but not cooling properly, or you're hearing grinding noises from behind the unit, the condenser fan motor has likely failed. This hub covers the 833697 condenser fan motor kit — a direct replacement that fits over 20 Whirlpool, Maytag, KitchenAid, Kenmore, Amana, and Jenn-Air side-by-side and bottom-freezer models.

Is This the Right Part for Your Model?

You'll find your model number on a label inside the fresh food compartment — usually on the left or right side wall, near the top. It's a combination of letters and numbers like ED25DQXBW00 or MSD2756AEW. Cross-reference it with the compatibility list below. This motor replaces AP3120994, PS395284, 10884507, and 833697VP.

About This Replacement Part

The condenser fan motor sits beneath or behind your refrigerator, pulling air across the condenser coils to dissipate heat. When it fails, you'll notice the fridge and freezer sections both warming up — the compressor keeps running but can't cool effectively because the coils can't release heat. Common symptoms include constant running, unusually warm temperatures in both compartments, and grinding or squealing noises from the back. This complete kit includes the motor, mounting bracket, and blade, making it a straightforward swap for the failed unit.

Why This Motor Fails

Condenser fan motors typically fail after years of continuous operation. Dust and pet hair buildup restricts airflow and forces the motor to work harder. The bearings wear out, causing wobble and noise before complete failure. In humid environments, moisture can corrode the electrical connections. You might notice the fridge running longer cycles for weeks before the motor seizes completely and stops cooling altogether.

Common Warning Signs

• Fridge runs constantly: The compressor never shuts off because the coils stay hot
• Both sections too warm: Fresh food around 50°F and freezer above 20°F
• Grinding or buzzing noise: Worn bearings create friction before seizing
• Intermittent cooling: Motor spins inconsistently, causing temperature swings
• Complete shutdown: Motor won't start, compressor may overheat and trip

Compatible Model Series

This 833697 motor works across multiple Whirlpool Corporation brands. It's commonly found in side-by-side models from the early 2000s through 2010s, including the Gold line, Estate series, and various KitchenAid built-ins. Maytag side-by-sides from the MSD and MZD series use this exact motor. Check your specific model below — the motor fits identically across these platforms since they share the same refrigeration platform.

What's Included in This Kit

You're getting everything needed for the repair: the replacement motor with pre-installed electrical leads, a mounting bracket, and the fan blade. The motor is rated for the same specifications as the original — voltage, amperage, and CFM output match factory specs. The blade diameter and pitch are identical to what came with your fridge, so you don't need to swap components or make modifications.

Installation Overview

This is a rear-access repair. You'll unplug the fridge, pull it away from the wall, and remove the lower back panel. The condenser fan sits next to the compressor — usually held by two or three screws. Disconnect the wire harness, unbolt the old motor, and reverse the process with the new one. The entire job takes 20-30 minutes if you've got basic tools and a clear workspace. Make sure the blade spins freely before you plug the fridge back in.