Whirlpool & Kenmore Washer Timer Knob Parts — Models & Compatibility

Your washer won't start, and you're pretty sure it's not a major electrical issue — it's that timer knob. Whether it's cracked, won't turn, or simply spins without engaging the timer mechanism, this simple plastic component can completely shut down your Whirlpool or Kenmore washer. This hub covers the 3362624 timer knob replacement, compatible across dozens of 110-series Kenmore models and their Whirlpool equivalents.

Is This the Right Part for Your Model?

The 3362624 timer knob (also sold as WP3362624, AP6008101, and PS11741232) fits a wide range of Kenmore 110-series washers. Your model number is stamped on a metal plate inside the washer lid or on the back panel near the top. Look for numbers starting with 110.82, 110.92, or 110.81 — these are the primary series using this knob design. If your timer shaft is a D-shaped post about 1/4 inch diameter, you're in the right place.

About This Replacement Part

This timer knob is a direct-fit replacement for models where the original white or almond-colored knob has cracked, stripped internally, or broken off entirely. The most common failure is the knob spinning freely without advancing the timer — this happens when the internal D-shaped socket wears out or cracks. When this part fails, your primary symptom is a washer that will not start, even though you can hear the timer mechanism clicking inside. The replacement knob is injection-molded plastic with a reinforced D-socket that press-fits directly onto the timer shaft without tools or screws.

Compatible Washer Models

This timer knob replacement works across Kenmore 110-series top-load washers manufactured primarily in the 1990s and early 2000s. Below are verified compatible models:

• 110.82891120 — Kenmore
• 110.828918100 — Kenmore
• 110.828918110 — Kenmore
• 110.828918120 — Kenmore
• 110.828918130 — Kenmore
• 110.8293130 — Kenmore
• 110.92093320 — Kenmore
• 110.92093720 — Kenmore
• 110.92293510 — Kenmore
• 110.92570200 — Kenmore
• 110.816611 — Kenmore
• 110.816613 — Kenmore
• 110.816616 — Kenmore
• 110.816617 — Kenmore
• 110.816618 — Kenmore

Additional compatible models exist beyond this list. If your Kenmore washer model starts with 110.82, 110.92, or 110.81 and has a white timer knob on the control panel, this is likely your replacement part.

Installation Overview

Installing this timer knob is straightforward. First, unplug the washer. The old knob typically pulls straight off the timer shaft — if it's stuck, gently wiggle while pulling. The new knob presses onto the D-shaped timer shaft until it's flush against the control panel. You'll feel it seat firmly. No adhesive or fasteners are needed. Plug the washer back in and test timer rotation through a full cycle.

Why This Part Fails

Timer knobs fail because they're gripped and turned dozens of times per week under varying hand pressures. Over years, the plastic fatigues. The D-shaped socket inside the knob either cracks or wears oval-shaped, allowing the knob to spin without engaging the timer shaft. Temperature swings in laundry rooms accelerate plastic embrittlement. Once the knob fails, you'll notice it either spins freely or requires excessive force to turn, and the timer won't advance your wash cycle.

Order Your Replacement Timer Knob

The 3362624 washer timer knob is available for $40.99. This is a genuine OEM-equivalent replacement, not a flimsy aftermarket substitute. Ships ready to install with no additional parts required.