Frigidaire Refrigerator Water Inlet Valve Parts — Models & Compatibility

When your Frigidaire's ice maker stops making ice or the water dispenser quits working, the water inlet valve is usually the culprit. This triple-solenoid valve controls water flow to both the ice maker and dispenser — and when it fails, you'll know. The 242252702 water inlet valve is the direct replacement for over 20 Frigidaire and Electrolux side-by-side refrigerator models, particularly the FFHS and FFSS series built between 2010-2018.

Is This the Right Part for Your Model?

Check your refrigerator's model number plate — it's typically located inside the fresh food compartment on the left wall or behind the crisper drawers. If your model starts with FFHS23, FFHS26, FFHS27, or FFSS23, this valve will fit. Cross-reference your full model number with the compatibility list below to confirm. This valve also replaces part numbers AP5671757, 241734301, 240321801, and PS7784018.

About This Replacement Part

The 242252702 is a triple-solenoid water inlet valve that manages water flow to three separate circuits: ice maker fill, water dispenser, and sometimes an additional line depending on your model's configuration. The valve typically fails when one of the solenoids sticks open or closed — you might hear a half-second growl when pressing the dispenser lever but get no ice, or the valve might leak water underneath the fridge. Some owners report the solenoid working intermittently: "I can adjust the solenoid mechanic a little bit and it will work for a while," one technician noted, which is textbook sticking-solenoid behavior. Installation takes 15-30 minutes with basic tools. One important note: newer replacement valves use push-to-connect (shark bite) fittings instead of threaded connections, so you'll need to cut off the old B-nuts from your existing water lines and push them directly into the color-coded fittings on the new valve.

Compatible Frigidaire Refrigerator Models

This water inlet valve fits the following Frigidaire, Electrolux, and Kenmore refrigerator models:

• FFHS2322MSGA — Frigidaire 22.1 Cu. Ft. Side-by-Side
• FFHS2322MBLA — Frigidaire 22.1 Cu. Ft. Side-by-Side
• FFHS2322MSLA — Frigidaire 22.1 Cu. Ft. Side-by-Side
• FFHS2322MB7 — Frigidaire 22.1 Cu. Ft. Side-by-Side
• FFHS2322MBE — Frigidaire 22.1 Cu. Ft. Side-by-Side
• FFHS2322MW9 — Frigidaire 22.1 Cu. Ft. Side-by-Side
• FFHS2322MWEA — Frigidaire 22.1 Cu. Ft. Side-by-Side
• FFSS2325TS0 — Frigidaire 22.3 Cu. Ft. Side-by-Side
• FFHS2611LBA — Frigidaire 25.5 Cu. Ft. Side-by-Side
• FFHS2611LBB — Frigidaire 25.5 Cu. Ft. Side-by-Side
• FFHS2611PF1 — Frigidaire 25.5 Cu. Ft. Side-by-Side
• FFHS2311LB9 — Frigidaire 22.6 Cu. Ft. Side-by-Side
• FFHS2311LBA — Frigidaire 22.6 Cu. Ft. Side-by-Side
• FFHS2313LS0 — Frigidaire 22.6 Cu. Ft. Side-by-Side
• FFHS2313LS2 — Frigidaire 22.6 Cu. Ft. Side-by-Side
• FFHS2622MS4 — Frigidaire 25.5 Cu. Ft. Side-by-Side
• FFHS2622MS6 — Frigidaire 25.5 Cu. Ft. Side-by-Side
• FFHS2622MSE — Frigidaire 25.5 Cu. Ft. Side-by-Side
• FFHS2611LWM — Frigidaire 25.5 Cu. Ft. Side-by-Side
• FFHS2611PFM — Frigidaire 25.5 Cu. Ft. Side-by-Side

Note: This is a representative sample. Check your exact model number against the full compatibility list or contact support if you're unsure.

Common Symptoms Indicating You Need This Part

• Ice maker not making ice
• Water dispenser not dispensing water
• Ice maker won't dispense ice
• Water leaking underneath the refrigerator
• Growling noise when pressing dispenser lever but no water flow
• Ice maker dispenses too little ice

Installation Overview

Replacing this valve is straightforward. Unplug the fridge, shut off the water supply, and remove the lower back panel. Disconnect the electrical harness and water lines from the old valve — you'll need an adjustable wrench, pliers, and a nutdriver. The new valve uses color-coded push-to-connect fittings, so match blue to blue, red to red, etc. One installer noted: "Lines and connectors are color coded so it is easy to match up lines to proper fittings, and female to male electrical connectors." The entire job takes 15-30 minutes for someone with basic DIY skills.

Tools You'll Need

• Nutdriver set
• Adjustable wrench
• Pliers
• Flathead and Phillips screwdrivers
• Towel (to catch water residue)

Why This Part Fails

The water inlet valve typically fails due to a sticking solenoid or worn internal seals, leading to water flow issues. Mineral deposits from hard water can cause the solenoid to stick, which explains why some users experience intermittent operation. In other cases, the rubber seals inside the valve degrade over time, causing leaks. If you're seeing water pooling under your fridge or your ice maker suddenly stopped working after years of reliable service, this valve is almost always the fix.

Order Your Replacement Valve

Get the 242252702 water inlet valve delivered to your door. We stock genuine OEM-quality replacement parts for Frigidaire, Electrolux, and Kenmore refrigerators. Questions about compatibility? Our team has 20+ years of appliance repair experience — call us seven days a week and we'll walk you through it.