Samsung Washer Water Inlet Valve Parts — Models & Compatibility

Your Samsung top-load washer won't fill with water, or it's filling too slowly—chances are the water inlet valve has failed. This replacement part (DC62-30314N) fits a wide range of Samsung front-load and top-load models, from the compact WA40J series to newer WA44A models. If you've heard clicking sounds but see no water entering the tub, or your washer displays fill errors, this valve is the likely culprit.

Is This the Right Part for Your Model?

Check your washer's model number before ordering. You'll find it on a label inside the door frame (front-loaders) or under the lid near the control panel (top-loaders). This DC62-30314N valve replaces part numbers DC62-30314V, AP5966634, PS11719664, and 3992464—so if your Samsung documentation lists any of those numbers, you're in the right place. The valve controls both hot and cold water flow into your washer drum.

About This Replacement Part

The water inlet valve is an electrically-controlled solenoid valve that opens when your washer needs water. Over time, mineral deposits from hard water can clog the valve screens, or the solenoid coils can burn out—both scenarios prevent proper water flow. This part includes the valve body, solenoid coils, and mounting bracket. You'll need to shut off the water supply hoses before installation and have a bucket handy to catch residual water. The valve connects to your washer's fill hoses and wiring harness with push-on connectors, making it a straightforward swap once you access the rear panel.

Compatible Samsung Washer Models

This water inlet valve fits the following Samsung washer models. If your model number isn't listed but starts with a similar prefix, verify compatibility using the part numbers above:

• WA40J Series: WA40J3000AW/A2, WA40J3000AW/AA
• WA45N Series: WA45N3050AW/A4
• WA41A Series: WA41A3000AW/A4
• WA44A Series: WA44A3205AW/A4
• WA10F Series: WA10F5S2QWW

Why Samsung Inlet Valves Fail

Most inlet valve failures happen gradually. You might notice your washer taking longer to fill, or cycles pausing with error codes like 4C or 4E (water supply errors). Sometimes the valve sticks partially open, causing slow drips even when the washer is off—leading to potential water damage if left unchecked. Hard water areas see more frequent failures because calcium buildup restricts the valve screens. If your home has sediment in the water lines, those particles accelerate wear on the valve's rubber seals.

Installation Overview

Replacing this valve is a rear-panel job. Unplug the washer and turn off both hot and cold water supply valves. Disconnect the fill hoses from the back of the washer—expect some water spillage here. Remove the screws securing the rear access panel (usually 4-6 screws). The inlet valve is mounted near where the hoses connect. Disconnect the wire harness from the valve, remove the mounting screws, and pull out the old valve. Install the new valve in reverse order, making sure the wire connections are firm and the hoses seal properly. Turn the water back on slowly and check for leaks before running a test cycle.

Order Your Replacement Valve

The DC62-30314N is in stock at $85.99 and ships with a manufacturer warranty. It's the exact replacement for Samsung part numbers DC62-30314V, AP5966634, PS11719664, and 3992464. Verify your model number against the list above, and if you're unsure about compatibility, contact our parts team with your full model and serial number—we'll confirm fitment before you order.