Whirlpool & Maytag Washer Water Inlet Valve Parts — Models & Compatibility

If your Whirlpool or Maytag top-load washer won't fill with water — or worse, it's leaking behind the machine — the water inlet valve is usually the culprit. This W10683603 valve assembly controls hot and cold water flow into the tub and fits dozens of WTW and MVWC series models. Whether you're dealing with no water at all or a slow trickle that takes forever to fill, this is the part you need.

Is This the Right Part for Your Model?

This valve fits most Whirlpool WTW4000-4900 series and Maytag MVWC200-360 series washers manufactured between 2012-2018. Your model number is printed on a sticker inside the washer lid or along the top rim of the tub opening. Look for model numbers starting with WTW47, WTW48, WTW49, or MVWC2 through MVWC3. Cross-reference your full model number against the compatibility list below before ordering.

About This Replacement Part

The W10683603 is a dual-inlet valve assembly that mounts to the back of your washer and connects to both hot and cold water supply hoses. It contains two electric solenoids that open and close to control water temperature during fill cycles. Common failure symptoms include complete water flow stoppage (no water entering the tub), mixing only cold water regardless of cycle selection, or water leaking from the valve body itself — usually visible as a puddle behind the washer. This valve replaces older part numbers WPW10683603, W10423125, W10501149, and W10683680, so if you've got one of those listed in your washer's documentation, this is your updated replacement.

Common Problems This Part Solves

• Leaking: Water pooling behind the washer, often from cracked valve housing or failed internal seals
• No hot or cold water: One or both solenoids have failed, preventing water from entering the tub
• Water filling issues: Slow fill times, weak water flow, or fills that stop mid-cycle

Compatible Whirlpool & Maytag Models

This valve works with the following washer models. We've listed the most common series below:

Don't see your exact model? Check the full compatibility list at the product link — this valve fits over 50 WTW and MVWC configurations.

Installation Overview

You'll need to pull the washer away from the wall to access the back panel. Shut off both hot and cold water supply valves, then disconnect the inlet hoses (have a towel ready — there's always residual water in the lines). The valve is held in place with two mounting screws and has wire harness connectors for each solenoid. Removal takes about 10 minutes once you've got access. Installation is just the reverse: mount the new valve, reconnect wiring harnesses, reattach water supply hoses (hand-tight plus a quarter turn with pliers), and check for leaks during the first fill cycle.

Part Specifications

• Part Number: W10683603
• Replaces: WPW10683603, W10423125, W10501149, W10683680, AP6023768
• Fits Brands: Whirlpool, Maytag, Amana, Kenmore (select models)
• Price: $70.99
• Type: Dual-inlet solenoid valve assembly

Why This Part Fails

Water inlet valves fail from mineral buildup in hard water areas — calcium deposits clog the mesh screens inside the valve or prevent solenoids from opening fully. The rubber seals and diaphragms inside also deteriorate over time from constant water pressure and temperature changes. If you've noticed your washer taking longer to fill over the past few months, that's early valve failure. Complete stoppage or leaking means the valve's already done.