GE Washer Water Inlet Valve Parts — Models & Compatibility

If your GE top-load washer only fills with cold water or won't stop dripping after the cycle ends, you're likely dealing with a failed triple water inlet valve. This hub covers the WH13X10053 replacement valve that fits over 100 GE and Hotpoint washer models from the GTWN and GCWN series. Most owners complete this repair in 15-30 minutes without moving the machine.

Is This the Right Part for Your Model?

Check the model number plate on your GE washer — it's typically located inside the lid or on the back panel near the top. If your model starts with GTWN, GCWN, or GTWP (like GTWN4250D0WS or GTWN5650F2WS), this valve is likely compatible. Cross-reference your complete model number with the compatibility list below before ordering.

About This Replacement Part

The WH13X10053 is a factory OEM triple water inlet valve that controls hot, warm, and cold water flow into your washer. This valve fails when internal solenoids wear out or debris prevents the valve from closing completely — which is why you'll see that constant drip or lose hot water capability altogether. The valve connects directly to your home's water supply lines and uses three electrical solenoids to control water temperature mixing. One technician noted the valve replacement "took about 10 minutes" once they accessed the control panel, though you'll want to budget 15-30 minutes if this is your first time.

Common Failure Symptoms

• Only cold water fills: Hot water solenoid has failed, preventing warm or hot wash cycles
• Continuous dripping: Valve won't close properly, wasting water between cycles
• No water flow: Complete valve failure or debris blockage in inlet screens
• Slow fill times: Partially clogged valve or weak solenoid operation

What You'll Need for Installation

This repair requires basic hand tools: 1/4" hex nut driver or socket set for the control panel screws, pliers for the hose clamps, and a Phillips screwdriver. One important tip from experienced installers — be careful removing the hard plastic hose from the valve as you loosen the hose clamp. The plastic can crack if you force it. Most repairs happen from the front of the machine after tilting the control panel forward, so you won't need to pull the washer away from the wall.

Installation Overview

1. Unplug washer and shut off water supply valves
2. Remove control panel screws (typically three 1/4" hex screws)
3. Tilt control panel forward to access valve mounting area
4. Disconnect water supply hoses from valve (have towels ready)
5. Unplug electrical connectors from valve solenoids
6. Remove two mounting screws holding valve in place
7. Install new valve and reconnect all hoses and wires
8. Test by running a short cycle and checking for leaks

As one DIYer put it: "The simplicity of this repair surprised me. From start to finish the whole process took less than half an hour." If you can access the back of your washer easily, you might find it even faster — but front access works fine for most installations.

Why This Valve Fails

Water inlet valves fail from regular wear over 5-10 years of use. The solenoid coils that open and close the valve eventually weaken, and mineral deposits from hard water can prevent complete closure. If you've noticed your washer dripping between loads or only filling with cold water regardless of temperature setting, the valve's internal components have likely worn out. Replacing the entire valve assembly is more reliable than attempting to clean or repair individual solenoids.

Compatible GE & Hotpoint Washer Models

This WH13X10053 valve fits the following models. Note: This is a representative sample — verify your specific model number before ordering.

Replacement Part Numbers

This valve replaces several part numbers used across different model years: AP5629504, WH13X22314, PS3652834, and 2692250. If you're looking up parts by these numbers, they all refer to the same updated valve assembly.