Free Shipping $49+
Factory Direct No Middleman
30-Day Returns
24/7 1-800-HEIMA-00
Dishwasher leaves standing water in the tub at the end of the wash cycle due to a failed drain pump motor or impeller.
Bosch/Thermador E24 drain error triggered when the pump motor fails to evacuate water within the expected time window.
E25 fault indicating the pump is blocked or not running — often caused by a seized motor rather than an actual clog.
Pump cycles on and off during the drain phase but never fully empties the tub, leaving residual water in the sump.
Worn bearing or damaged impeller inside the pump causes a grinding or buzzing sound during the drain portion of the cycle.
💡 Pro Tip: How to Confirm Your Drain Pump Has Failed
Your part is likely the culprit if you notice any of the following:
⚠️ Standing water remains in the tub after the cycle completes
⚠️ E24 or E25 error code displayed — drain path already confirmed clear
⚠️ Pump runs intermittently or cycles on and off without fully draining
⚠️ Loud grinding or humming noise coming from the pump area during drain phase
🔍 Diagnostic tip: Remove the pump and test the motor windings with a multimeter set to continuity mode. No continuity = failed motor. If the impeller shaft spins freely but the motor reads open, replace the pump. Always verify the drain hose, filter screen, and flapper valve are clear before condemning the pump.
📦 What's in the Box
✅ 1× Dishwasher Drain Pump Assembly (54V / 55Hz / 3-Phase, replaces 00611332)
We typically respond within 1 business day. Include your appliance model number for the fastest answer.
Disclaimer: Compatibility information, part numbers, and model fitment data on this page are sourced from manufacturer databases and third-party references. While we strive for accuracy, please verify your appliance model number before ordering. Heima is not responsible for errors or omissions in compatibility listings.
Reviews
There are no reviews yet.