Whirlpool Washer Door Hinge Parts — Models & Compatibility

If you own a Whirlpool front-load washer from the WFW series, you're probably familiar with that sagging door issue that gets worse over time. This hub covers the WP8183202 door hinge replacement — the part that keeps your washer door aligned and prevents it from dropping or binding when you open it. We'll show you which models use this hinge and what you need to know before ordering.

Is This the Right Part for Your Model?

The WP8183202 hinge fits Whirlpool, Maytag, Kenmore, and Amana front-load washers manufactured roughly between 2007-2015. Your model number is stamped on a label inside the door opening — you'll see it when you open the washer door and look along the frame. Models starting with WFW9200, WFW9300, and WFW9400 almost certainly use this hinge. Cross-reference your complete model number with our compatibility list below to confirm.

About This Replacement Hinge

This door hinge (also sold as 8183202, W10005090, and W10200695) is the load-bearing pivot point for your washer's front door. When it fails, you'll notice the door doesn't close flush anymore, or it requires lifting to latch properly. One critical installation detail: this hinge does not come pre-threaded. You'll need to use self-tapping screws to thread the mounting holes during installation — don't try forcing standard machine screws or you'll strip the plastic. The hinge attaches to both the door frame and the outer tub, so you're basically rehinging the entire door assembly.

Compatible Whirlpool Washer Models

This hinge works with these specific model numbers:

• WFW9200 Series: WFW9200SQ00, WFW9200SQ01, WFW9200SQ02, WFW9200SQA10, WFW9200SQA11, WFW9200SQA12
• WFW9300 Series: WFW9300VU02, WFW9300VU03
• WFW9400 Series: WFW9400SB00, WFW9400ST00, WFW9400SU00, WFW9400SU01, WFW9400SW00, WFW9400SW01

These models represent the most common Whirlpool Duet and Duet HT washers that use this hinge design. If your model starts with WFW and has a similar number pattern, check the full compatibility list on the product page to verify.

Installation Considerations

Replacing a washer door hinge isn't a five-minute job. You'll need to remove the door from the washer, disassemble the door panels to access the hinge mounting points, then reassemble everything in reverse. Because the hinge holes aren't pre-threaded, your first time threading the self-tapping screws determines how solid the repair will be — go slowly and keep everything square. Budget about 45-60 minutes if you've never done this before.

Why This Hinge Fails

The WP8183202 hinge carries the full weight of a glass-and-metal door that gets opened and closed thousands of times. Over years of use, the plastic mounting points develop stress cracks, or the hinge pivot wears enough that the door starts sagging. You'll know it's time when the door won't stay open at certain angles, or when you have to lift the door slightly to get it to latch. Catching this early prevents damage to the door latch and outer tub seal.