GE & Hotpoint Dryer Main Control Knob Parts — Models & Compatibility

Your GE or Hotpoint dryer won't start, or the timer dial just spins without catching? The main control knob (part WE03X25285) is what connects your hand to the timer mechanism inside — when it strips out or cracks, you're left with a dryer that won't respond to your commands. This hub covers the direct replacement knob that fits multiple GE, Hotpoint, and RCA dryer models from their front-load and top-load series.

Is This the Right Part for Your Model?

Check your dryer's model number label — it's usually inside the door frame or on the back panel near the power cord. Match it against the compatible models list below. This knob replaces AP6032623, PS11763058, and 4467014, so if you've found those part numbers in your research, you're in the right place. The knob mounts directly onto the timer shaft — no drilling, no modifications.

About This Replacement Part

The WE03X25285 control knob is the plastic dial you grip to select drying cycles and start your dryer. Over time, the internal teeth that grip the timer shaft wear down or crack — especially if the knob gets forced or if someone yanks it while the mechanism is engaged. When this happens, you'll notice the timer not working properly or the dryer simply won't start because the knob can't engage the timer contacts. This replacement uses the same mounting design as the original factory part, with reinforced internal teeth that grab the D-shaped timer shaft. It's a straightforward swap: pull off the old knob, press on the new one until it seats firmly against the control panel. No tools required, takes about 30 seconds.

Common Issues This Part Fixes

• Timer Not Working: Knob spins freely without engaging the timer mechanism underneath
• Won't Start: Dryer doesn't respond when you turn the dial to start position
• Loose or Wobbly Knob: Internal mounting teeth have stripped out, knob doesn't stay in selected position

Compatible Model Series

This control knob fits dryers across GE's GTX and NTX series, plus Hotpoint's HTX lineup. You'll find it on both electric and gas models from these product lines. The knob works with standard cycle timers — if your model has electronic touch controls instead of a dial, this isn't your part.

Installation Overview

No repair experience needed for this one. Unplug the dryer, grip the old knob firmly and pull straight out — it friction-fits onto the timer shaft. If it's stuck, wiggle it gently side to side while pulling. Line up the new knob with the D-shaped shaft (there's only one way it fits), then push firmly until the knob seats flush against the control panel. Plug the dryer back in and test all cycle positions to confirm the timer engages properly.

What You're Getting

One white plastic control knob with cycle markings. The knob includes the internal mounting collar with D-shaft fitting. It's designed to match the original GE/Hotpoint appearance and function — same size, same grip, same feel when you turn it.