GE & Hotpoint Dryer Lint Filter Parts — Models & Compatibility

If your GE or Hotpoint dryer is taking longer to dry clothes or you're seeing lint buildup around the door seal, you probably need a new lint filter. This WE03X23881 replacement fits dozens of GE and Hotpoint dryer models — it's one of the most universal lint filters in their lineup. Whether you've got a GTD33EASK0WW or a GTD42EAMJ0WW, this filter drops right into place.

This part replaces several older part numbers including AP6031713, PS11763056, 4476390, and EAP11763056. If you're holding one of those numbers from your service manual, you're in the right spot.

Is This the Right Part for Your Model?

Check your dryer's model number — it's usually on a sticker inside the door frame or on the back panel near the power cord. Match it against the compatibility list below. GE used this same filter design across their entire front-load dryer line from the early 2000s through recent models, so there's a good chance yours is compatible. If your current filter has cracks, tears in the mesh, or the frame is warped from heat, it's time to replace it.

About This Replacement Part

The WE03X23881 is a full-size lint trap assembly with a rigid plastic frame and fine mesh screen. It slides into the front panel slot and catches lint before it clogs your exhaust system. A damaged or missing lint filter is the #1 cause of extended dry times and potential fire hazards — lint buildup in the duct can ignite from dryer heat. This replacement restores proper airflow and keeps your dryer running efficiently. The mesh is heat-resistant and designed to handle commercial-grade lint loads, so it'll outlast generic aftermarket versions. Installation takes about 30 seconds — just pull out the old filter and slide this one into the same slot until it clicks.

Compatible GE & Hotpoint Dryer Models

This lint filter works with the following model series:

• GTD33 Series: GTD33EASK0WW, GTD33EASKOWW
• GTD42 Series: GTD42EAMJ0WW
• LAT Series: LAT1000AAE
• Cross-Reference Numbers: WE03X23881, PS11763056, AP6031713, W10549851, W10135699, PS1960673, W10501250, W10346771A, PS3503014, MCS62101805, PS12739141, W11179302, PS12583750

This filter fits over 50 GE and Hotpoint dryer models. If your model number starts with GTD, GTDP, or LAT, it's likely compatible.

Why Replace Your Lint Filter?

Even if your current filter looks okay, a warped frame or stretched mesh reduces airflow. You'll notice clothes taking two or three cycles to dry fully, or the dryer running hot without actually drying anything. That's your filter telling you it's done. A new filter restores efficiency and cuts your energy bill — a clogged lint system makes your dryer work twice as hard.

Installation & Maintenance Tips

Clean your new lint filter after every load — it takes five seconds and prevents 90% of dryer problems. Pull it straight out, brush off the lint with your hand, and slide it back in. Every few months, wash the filter with warm soapy water to remove fabric softener residue that clogs the mesh. Let it air dry completely before reinstalling. And while you've got the filter out, use a vacuum hose to clean the filter slot — you'd be surprised how much lint hides in there.

Order Your Replacement Filter

The WE03X23881 lint filter is in stock at $30.99 with fast shipping. It's a direct OEM-quality replacement — same specs as the original factory part. If you're tired of rewashing half-dry laundry or your dryer's throwing a high-temperature warning, this filter fixes it. Installation is tool-free and takes less than a minute.