GE Range Surface Burner Terminal Block Parts — Models & Compatibility

The terminal block is where your GE range's surface burner element connects to the electrical supply. When it fails — usually from heat stress or corrosion — you'll notice one specific symptom: the element simply won't heat up. No clicking, no glowing, nothing. This hub covers the WB17T10006 terminal block kit and compatible replacements for GE, Hotpoint, and Kenmore ranges.

Is This the Right Part for Your Model?

Check your range's model number before ordering. On most GE ranges, you'll find it on a metal tag inside the oven door frame or along the front panel when you pull the storage drawer. This terminal block (also sold as AP3203326, WB17T10009, WB17K10003, or WB17T10001) fits dozens of GE series models. Cross-reference your model number with the compatibility list below.

About This Replacement Part

The surface burner terminal block is a ceramic or high-temp plastic housing that holds the wire connectors between your burner element and the range's wiring harness. It's designed to handle repeated heating cycles, but over time the terminals can burn out — especially if moisture gets in or if you've experienced an element short. The most common failure pattern: element will not heat at all, even though the burner control knob clicks normally. If you've already tested the element itself and it's fine, the terminal block is almost always the culprit. This kit includes the block housing and wire terminals, everything you need for a complete repair.

Common Signs You Need This Part

• One burner element won't heat up, but control knob works
• Visible burn marks or melted plastic around burner connection
• Loose or corroded wire terminals at element base
• Range won't start when you turn burner knob to any setting

What's Included

This terminal block kit comes with the ceramic block housing, metal wire terminals, and mounting hardware. Installation typically takes 15-20 minutes if you're comfortable working with basic electrical connections. Always disconnect power at the breaker before starting any repair.

Compatible GE Range Models

This terminal block fits a wide range of GE, Hotpoint, and Kenmore electric ranges. Below are some of the most common compatible models:

• GE WB17T10006
• GE PS783534
• GE LAT1000AAE
• GE W10549851
• GE PS12345667
• GE W10135699
• GE PS1960673
• GE W10501250
• GE PS12345661
• GE W10346771A
• GE PS3503014
• GE MCS62101805
• GE PS12739141
• GE W11179302
• GE PS12583750
• GE AP3203326
• GE WB17K10003
• GE WB17T10001
• GE WB17X10007

Note: This is a partial list. If your model isn't shown here, check the product page for the complete compatibility chart or contact us for verification.