Whirlpool & Maytag Washer Lid Lock Assembly Parts — Models & Compatibility

If your Whirlpool or Maytag top-load washer clicks repeatedly but won't start, you're likely dealing with a failed lid lock assembly. This hub covers W11670519 lid lock compatibility across MVW-series washers — the models most prone to this exact failure. We'll show you which machines use this part and how to verify yours is compatible.

Is This the Right Part for Your Model?

Check your washer's model number before ordering. On most MVW-series machines, you'll find it inside the lid or on the back panel near the top. Cross-reference against our compatibility list below — if your model number matches, this W11670519 assembly will fit.

This lock assembly replaces older part numbers W11368616, AP7214714, PS17215992, and 4981394. If you've got an old work order or parts list showing any of these numbers, W11670519 is the current replacement.

About This Replacement Part

The lid lock assembly does more than just click — it signals your washer's control board that it's safe to fill, agitate, and spin. When it fails, you'll typically see one of three symptoms: the washer won't start at all, it won't drain or spin (stuck mid-cycle), or the lid clicks over and over without engaging. A malfunctioning latch may result in issues such as a washer that won't start, drain, or spin, or a lid that clicks repeatedly.

Most MVW-series owners report this failure happening between years 3-5 of ownership. The locking mechanism wears out from normal use — there's no preventing it, just replacing it when it goes. Symptoms usually appear suddenly: one load it works fine, the next load it's clicking and refusing to run.

Common Model Series Using This Part

This lid lock fits across multiple Whirlpool and Maytag branding. The MVW4505, MVW5035, MVW5430, and MVW5435 series all use the same assembly. If you've got a top-load washer from either brand manufactured between 2015-2022, there's a strong chance this is your part.

What You're Actually Replacing

The complete assembly includes the lock mechanism, strike plate, and wiring harness. You're not just swapping a plastic latch — the entire electrical lock unit comes out as one piece. Installation takes about 20 minutes once you've removed the top panel and located the lock housing.

Verify Before You Order

Don't guess on compatibility. Pop the lid, find your model number, and match it against our list. If your washer's clicking but not locking, and your model's listed below, this assembly solves it. If your model isn't listed, contact us with your full model and serial number — we'll confirm fitment before you buy.