Whirlpool, Maytag & Kenmore Washer Tub Counter Balance Spring Parts — Models & Compatibility

If your Whirlpool, Maytag, or Kenmore washer has started doing the shuffle across your laundry room floor during spin cycles, you're probably dealing with a worn tub counter balance spring. This suspension spring keeps the drum stable during high-speed spinning — when it fails, you'll know it. One owner described it perfectly: after replacing all springs and tub wear pads, his wife suggested he quit his day job and do appliance repair full-time.

Is This the Right Part for Your Model?

Part W10250667 (replaces WPW10250667, AP6017818, 338492, 388492, 62738, and 63207) fits over 100 Whirlpool-family washer models. Your model number is typically located inside the washer door rim or on the back panel. Check it against our compatibility list below — we've included the most common series, from Kenmore 110 models to Whirlpool Duet and Maytag Bravos units.

About This Replacement Part

The tub counter balance spring is one of four suspension springs that anchor your washer drum to the cabinet frame. These springs absorb the violent forces during spin cycles — we're talking 1,200 RPM with a full load of wet clothes. Over time, they stretch, weaken, or snap completely. When that happens, the tub becomes unbalanced, causing the machine to shake violently, walk across the floor, or even leak if the drum tilts enough to breach seals. This is textbook wear-and-tear failure, typically showing up after 5-8 years of regular use.

Common Symptoms That Point to This Part

You'll notice shaking and moving during spin cycles — not just gentle vibration, but aggressive walking that leaves your washer several inches from where it started. Some machines develop leaking when the unbalanced drum stresses door seals or hose connections. Spinning issues are also common: the washer may refuse to enter high-speed spin, or it'll attempt it but shut down mid-cycle when vibration sensors detect the problem.

Installation Overview

This is a moderate difficulty repair that takes 30-60 minutes. You'll need to remove the washer cabinet to access the suspension system underneath the tub. As one DIYer described it: "Took washer casing off to put suspension spring on underneath. Used pliers to pull the spring to hook into the proper hole." That's the key challenge — these springs are under significant tension, so you'll need pliers or a socket set to stretch them into position. While you're in there, inspect the other three springs and the tub wear pads. If one spring failed, the others aren't far behind.

Tools You'll Need

• Pliers (needle-nose work best for hooking springs)
• Screwdriver set (to remove cabinet panels)
• Socket set (for mounting brackets)
• Work gloves (springs can pinch)

Why Replace This Part?

At $9.99, this spring costs less than a single service call. The alternative is continuing to run an unbalanced machine, which accelerates wear on bearings, shocks, and the drive system. Ignored long enough, a failed suspension spring can cause drum-to-cabinet contact that damages the tub itself — turning a simple $10 fix into a $300+ repair. Many owners replace all four springs at once as preventive maintenance, which makes sense if your machine is 5+ years old.

Compatible Models

This part fits Kenmore 110 series, Whirlpool Duet, Maytag Bravos, and KitchenAid front-load and top-load washers. Verify your specific model number before ordering — the list below includes the most common models we've confirmed: