Whirlpool & KitchenAid Dishwasher Tine Pivot Clip Parts — Models & Compatibility

That annoying rattle inside your dishwasher? Often it's a broken tine pivot clip—the tiny plastic piece that lets you adjust the upper rack tines. This W10082853 clip works across Whirlpool, KitchenAid, Kenmore, and Jenn-Air models, replacing the original part numbers WPW10082853, AP6014920, and PS11748190.

Is This the Right Part for Your Model?

Check your dishwasher's model number—it's usually on a sticker inside the door frame or along the top edge when you open the door. This clip fits over 50 models from the compatible list below. If your upper rack tines won't stay in position or you hear plastic pieces rattling around during the wash cycle, you've likely got broken pivot clips.

About This Replacement Part

The tine pivot clip is a small gray plastic component that anchors each adjustable tine to the upper rack. When they crack or break (usually from repeated folding and unfolding), the tines become loose or fall out completely. This is a genuine OEM replacement part at $10.99, sold individually. Most dishwashers have 6-10 of these clips on the upper rack, so if one's broken, check the others—they often fail around the same time. The clip snaps into place without tools, though you'll need to remove the upper rack to access the tines properly.

Why Tine Clips Break

These clips take constant stress every time you adjust tines to fit different dish sizes. Over time, the plastic fatigues and cracks, especially if you've got hard water that leaves mineral deposits on the rack assembly. You'll notice the problem when tines won't lock into position or when you hear clicking sounds during the wash cycle as loose tines vibrate.

Compatible Model Series

This clip works across multiple product lines from 2010-2023. The KDTE and KDTM series from KitchenAid use this same clip design, as do Whirlpool's WDF and WDT models. Kenmore-branded dishwashers manufactured by Whirlpool (model numbers starting with 665) also use this part.

Quick Installation Overview

Remove the upper rack from the dishwasher. Push down on the broken clip while pulling the tine out of its socket. Slide the new clip onto the base of the tine until it clicks. Reinsert the tine into the rack, making sure the clip seats properly in the mounting hole. Test the tine—it should fold smoothly and lock into position. No tools required, takes about 2 minutes per clip once you've got the rack out.