Samsung Dryer Drum Roller Support Parts — Models & Compatibility

Your Samsung dryer sounds like a freight train rolling through the laundry room. That rhythmic thumping or squealing noise? It's usually the drum roller support giving up after years of supporting 20+ pounds of wet clothes spinning at high speeds. The DC97-16782E drum roller support is the factory replacement that restores smooth, quiet operation across dozens of Samsung electric and gas dryer models from 2014 to present.

Is This the Right Part for Your Model?

Check your dryer's model number on the label inside the door frame or on the back panel near the power cord. This drum roller support assembly (also replaces DC97-16782B, AP6884453, and PS12720843) fits Samsung dryers in the DV, DVE, and DVG series. If your model number starts with DV42H, DV45H, DV48J, DV50K, DV52J, DV56H, DVE45N, DVE45T, DVE50R, or DVE52M, you're looking at the right part.

About This Replacement Part

The drum roller support is the bracket assembly that holds the rear drum rollers in place. These rollers bear most of the drum's weight while it spins, so they take constant abuse. Over time, the support bracket itself can crack or warp, causing the rollers to wobble even if they're still good. Samsung designed this as a complete assembly — you get the bracket and hardware in one package. It mounts to the rear bulkhead with four screws and typically comes with fresh rollers pre-installed or packaged separately. Most techs replace both the support and rollers together since you've already got the drum out. The DC97-16782E supersedes the earlier DC97-16782B part number but functions identically across all compatible models.

Compatible Samsung Dryer Models

This drum roller support works across Samsung's front-load and top-load dryer lines manufactured between 2014 and 2024. The part number appears in service manuals for both electric (DVE) and gas (DVG) models with 7.0 to 9.0 cubic foot capacities.

Installation Overview

Replacing the drum roller support requires pulling the dryer drum out completely. You'll disconnect the front panel, remove the drum belt, lift out the drum, then access the rear bulkhead where the support mounts. It's a 45-60 minute job if you've done it before, closer to 90 minutes for your first attempt. The trickiest part is getting the belt back on correctly when you reassemble everything — Samsung uses a specific routing pattern that's easy to mess up.

When to Replace This Part

Loud thumping during the cycle means the rollers or support have failed. Squealing that gets worse as the load gets heavier points to worn roller bearings. If your dryer stops mid-cycle with wet clothes and won't restart until it cools down, the motor might be overheating from dragging a misaligned drum. Replacing the drum roller support fixes all these issues and extends your dryer's life another 5-7 years.

Price and Availability

The DC97-16782E drum roller support retails for $98.99 and ships with all necessary mounting hardware. That's significantly cheaper than the $150-200 Samsung charges through authorized service centers. Most aftermarket suppliers stock this part since it's one of the most common Samsung dryer repairs. Order it along with a fresh belt (part DC93-00634A) and you'll have everything needed for a complete drum service.