Samsung Top Load Washer Suspension Rod & Spring Assembly Parts — Models & Compatibility

The suspension system in Samsung top-load washers takes a beating — it's what keeps your washer from walking across the laundry room during spin cycles. When those rods and springs start to fail, you'll hear loud banging during spin, see visible wobbling, or find your washer has literally moved several inches from where you left it. The DC97-16350C suspension rod and spring assembly is the critical component that restores stability to WA-series models.

Is This the Right Part for Your Model?

This suspension assembly specifically fits Samsung WA400 and WA422 series top-load washers. To verify compatibility, locate your model number on the rim of the tub opening or on the back panel near the power cord. You're looking for model numbers starting with WA400PJHDWR or WA422PRHDWR, followed by variant codes like /AA-0001, /AA-0002, or /AA-00. If your model starts with these prefixes, this DC97-16350C assembly will work.

About This Replacement Part

The suspension rod and spring assembly (Samsung part number DC97-16350C) replaces older part numbers including DC97-16350J, DC97-05280K, AP5623264, and PS4221572. Each washer uses multiple suspension assemblies — typically four rods positioned at corners of the tub — so if one has failed, the others are likely not far behind. This assembly includes both the telescoping suspension rod and the coil spring in a single unit, making replacement straightforward compared to servicing individual components. Most Samsung technicians recommend replacing all four suspension assemblies at once to maintain balanced support and prevent premature wear on the new parts.

Common Signs You Need This Part

Suspension rod failure doesn't happen overnight. You'll notice the washer becoming progressively louder during the spin cycle, particularly when handling heavy loads like towels or jeans. The tub may bang against the cabinet sides, and you might see the entire machine rocking or walking forward. In severe cases, the washer will display error codes related to unbalanced loads even after you've redistributed the clothing. If you open the cabinet and see a suspension rod that's collapsed, leaking fluid, or has a visibly stretched or broken spring, replacement is the only fix.

Compatible Samsung Washer Models

This DC97-16350C suspension assembly works with the following Samsung top-load washer models. Most are in the WA400 and WA422 series, known for their 4.0-4.2 cubic foot capacity and direct drive motor systems:

• WA400PJHDWR/AA (variants 0001, 0002, 0003, 01, 02, 03)
• WA422PRHDWR/AA (variants 0000, 0001, 0002, 00, 01, 02)

These model series were manufactured primarily between 2011 and 2015 and share the same suspension system design. The variant codes after the slash indicate production date ranges and minor feature differences, but the mechanical suspension components remain identical across all variants.

Installation Considerations

Replacing suspension rods requires tilting the washer back or laying it on its front panel to access the underside of the tub. You'll need to disconnect the old rod from both the tub mounting point and the base frame — both connections use clips or bolts depending on your specific variant. The spring tension isn't under dangerous load when disconnected, but the assemblies are positioned in tight spaces that require patience. Budget about 15-20 minutes per suspension rod once you have the washer opened up, and remember that Samsung suspension systems work best when all four rods match in condition and compression characteristics.