Samsung Dryer Idler Pulley Bracket Assembly Parts — Models & Compatibility

If your Samsung dryer sounds like it's grinding rocks or the drum refuses to turn, you're likely dealing with a failed idler pulley bracket assembly. This DC96-00882C replacement fits dozens of Samsung dryer models from the DV42H through DV48H series and beyond. When this bracket wears out or cracks, the drum belt loses proper tension — and your dryer either screams at you or sits there doing absolutely nothing.

Is This the Right Part for Your Model?

Check your model number on the inside of the dryer door frame or along the right edge when you open the door. If you've got a DV42H5000EW, DV45H7000EW, DV48H7400EW, or any of the compatible models listed below, this DC96-00882C bracket is your match. Samsung used this same assembly across their mid-2010s dryer lineup, so chances are good if you own a Samsung dryer from that era, this part will fit.

About This Replacement Part

The idler pulley bracket assembly does one critical job: it holds the idler pulley wheel that maintains constant tension on your drum belt. When the bracket cracks or the pulley seizes up, you'll hear grinding, squealing, or rattling during operation. Sometimes the drum won't spin at all because the belt has slipped off completely. This isn't just annoying — it means your clothes aren't drying, and you're stuck with wet laundry. The DC96-00882C replaces older part numbers like DC93-00634A, DC96-00882B, and DC97-07509B, so if you're cross-referencing from an old repair manual, they're all the same updated assembly.

Common Failure Symptoms

Here's what you'll notice when this bracket goes bad. First, noise — lots of it. The pulley wheel starts making grinding or squealing sounds because the bearing inside has worn out. Second, the drum stops spinning entirely. The belt needs tension to turn the drum, and without a functioning idler assembly, that tension disappears. Third, your dryer won't start or it starts but immediately stops because the motor detects something's wrong with the belt system. All three symptoms point directly to this bracket assembly needing replacement.

What Makes This Part Fail

Normal wear and tear is the biggest culprit. Every time your dryer runs, that pulley wheel is spinning and the bracket is holding tension against the belt. Over thousands of cycles, the pulley bearing wears down and the plastic bracket itself can crack from the constant stress. Overloading your dryer accelerates this — cramming too many wet towels in there puts extra strain on the entire belt system. Sometimes lint buildup around the pulley causes it to seize, which then cracks the bracket when the motor tries to turn.

Models Compatible with DC96-00882C

This idler pulley bracket assembly works with these Samsung dryer models:

• DV42H5000EW/A3
• DV42H5000GW/A3
• DV42H5200EF/A3
• DV42H5200EP/A3
• DV42H5200EW/A3
• DV42H5200GW/A3
• DV45H6300EG/A3
• DV45H7000EW/A2
• DV45H7000GW/A2
• DV45K6200EW/A3
• DV45K6500EV/A3
• DV45K6500EW/A3
• DV48H7400EW/A2

And many more from the DV42H, DV45H, DV45K, and DV48H series. Always verify your exact model number before ordering.

Replacement Parts & Alternatives

The DC96-00882C supersedes several older Samsung part numbers. If you're finding references to DC93-00634A, DC96-00882B, or DC97-07509B in your dryer's service manual, this current assembly replaces all of them. Samsung consolidated these into one updated design. You might also see cross-reference numbers like AP6038887 or PS11771601 — same part, different supplier numbering systems.