LG Dryer Heating Element Parts — Models & Compatibility

If your LG dryer is running but leaving clothes cold and damp, or worse — tripping your circuit breaker — you're likely dealing with a failed heating element. The 5301EL1001J heating element assembly is the direct replacement for over 20 LG and Kenmore dryer models, from the DLE5955W to the DLEX series. One user put it simply after installation: "Replaced obviously burnt element with element assembly. Works beautifully now."

Is This the Right Part for Your Model?

Before ordering, verify your dryer's model number against the compatibility list below. On LG dryers, you'll find the model number on a label inside the door frame or on the back panel near the power cord. This element assembly replaces several part numbers including AP4439759, PS3527791, 1377645, and AH3527791 — so if you're cross-referencing an old service manual, those numbers all lead here.

About This Replacement Part

The heating element assembly generates the heat that dries your clothes. When it fails, you'll notice immediate symptoms: no heat whatsoever, or dangerous overheating that trips your breaker mid-cycle. Some elements develop visible burn marks or breaks in the coil before they fail completely. This is a complete assembly replacement — you're swapping out the entire unit, not repairing individual coils. With basic tools (pliers and screwdrivers) and 15-30 minutes, most DIYers rate this repair as easy. The element sits behind the dryer's rear panel, held in place by a mounting bracket and a few wire terminals.

Common Issues This Part Fixes

• Dryer runs but produces no heat — clothes stay wet after full cycle
• Circuit breaker trips repeatedly during drying
• Dryer overheats, shuts off, or scorches clothes
• Visible burn marks or breaks in heating coil

Installation Overview

This repair takes 15-30 minutes with basic hand tools. You'll need to disconnect power, remove the rear panel, disconnect three wire terminals from the old element, unbolt the mounting bracket, and reverse the process with your new assembly. The difficulty level is rated easy — if you can use a screwdriver and identify which wires go where (take a photo before disconnecting), you can handle this repair.

What's Included

Complete heating element assembly with mounting bracket and wire terminals — everything you need for a direct swap. No additional hardware required.

Compatible LG & Kenmore Dryer Models

This heating element fits the following models. If your model isn't listed, use our parts finder or contact us with your full model number: