LG & Kenmore Washer Tub Seal Gasket Parts — Models & Compatibility

The tub seal gasket on LG and Kenmore front-load washers sits between the outer tub and the bearing housing, preventing water from reaching the bearings during spin cycles. When this seal fails, you'll notice water leaking from underneath your washer or hear loud grinding noises as the bearings start to rust out. This hub covers the 4036ER2004A replacement seal and which models it fits.

Is This the Right Part for Your Model?

Check your washer's model number before ordering. On LG front-loaders, you'll find it inside the door frame or on a label behind the detergent drawer. Kenmore models (built by LG) have the tag in the same locations. Match your model exactly to the compatibility list below — the WM-series LG washers and their Kenmore equivalents use this specific seal design.

About This Replacement Part

The 4036ER2004A seal replaces part numbers AP4438637, PS3522855, and AH3522855. It's designed for LG's direct-drive front-load washers manufactured from the early 2000s through 2010. This rubber gasket creates a watertight barrier that keeps wash water in the tub assembly while allowing the inner basket to spin freely. When it wears out — usually after 8-12 years of use — water starts migrating past the seal and destroys the main bearings. You'll know it's time for replacement when puddles form under the washer after heavy loads or when you hear metal-on-metal grinding during the spin cycle.

Compatible LG & Kenmore Models

This seal fits the following washer models. If your model isn't listed, double-check the part number stamped on your existing seal:

• WM0001HTM, WM0001HTMA
• WM0532HW
• WM0642HS, WM0642HW
• WM0742HGA, WM0742HWA
• WM1333HW
• WM1355HR, WM1355HW
• WM1388HW
• WM1811CW, WM1832CW
• WM2011HW
• WM2032HS, WM2032HW
• WM2042CW, WM2050CW
• WM2075CW, WM2077CW

What You Need to Know Before Ordering

Replacing the tub seal isn't a quick repair. You'll need to disassemble the washer cabinet, remove the front panel, disconnect the door boot, and pull the entire tub assembly to access the seal. Most DIYers spend 2-3 hours on this job. Since you're already tearing down the washer this far, consider replacing the bearings at the same time — if the seal's failed, the bearings are usually compromised too.

Order Your Replacement Seal

The 4036ER2004A tub seal gasket is available for $23.99. Verify your model number matches the compatibility list, and you'll have the correct part for your LG or Kenmore washer.