Maytag & Jenn-Air Dryer Drum Drive Belt Parts — Models & Compatibility

If your Maytag or Jenn-Air dryer drum stopped spinning or sounds like a freight train, you're probably dealing with a worn or snapped drive belt. This 312959 replacement belt fits dozens of models across the DE, DG, and LSE series — the workhorses that ran through the 90s and 2000s. Below, you'll find model compatibility, installation tips, and what to expect when tackling this repair yourself.

Is This the Right Part for Your Model?

Check your dryer's model number tag — it's usually inside the door opening or on the back panel. Cross-reference it against the list below. Models like the DE110, LDE7304ACE, and LSE1000 are confirmed fits. If your model starts with DE, DG, or LSE from Maytag or Jenn-Air, chances are solid this belt will work. The part replaces WPY312959, Y312959, and AP6024192 — so if you've seen those numbers anywhere, you're in the right place.

About This Replacement Belt

This belt wraps around the drum, motor pulley, and tensioner to spin your clothes. Over time — we're talking years of regular use — the rubber cracks, stretches, and eventually snaps. You'll know it's gone when the drum won't turn even though the motor hums. Sometimes you'll hear scraping or see black marks on your clothes before it fully fails. One user replaced a broken belt on their Maytag and said it's "running smooth and quiet" again — exactly what you want. The swap takes 30 to 60 minutes if you've got a nutdriver, screwdriver set, and socket wrench handy. It's not beginner-level easy, but it's doable if you're comfortable pulling panels and working around a motor.

Common Failure Pattern

The belt typically fails due to wear and cracking over time. If your dryer's been in service for 10+ years without a belt change, you're overdue. Heat cycles, friction, and normal aging break down the rubber. You might notice the dryer getting louder before it quits — that's the belt slipping or fraying against the pulleys.

What You'll Need for Installation

• Nutdriver (usually 1/4" or 5/16")
• Flathead and Phillips screwdrivers
• Socket set for rear panel bolts
• Work gloves (those drum edges are sharp)

Plan for a moderate difficulty level. You'll need to tip the dryer, remove the front or top panel depending on model, and thread the new belt around the drum and pulleys in the correct configuration. It's not rocket science, but there's a specific routing pattern you need to follow or the drum won't spin properly.

Verified Compatible Models

This belt works across Maytag and Jenn-Air dryer models from multiple series. Below are confirmed fits pulled from compatibility data:

• Maytag DE106, DE107, DE110
• Maytag DE312, DE412, DE810, DE8500, DE9800
• Maytag DG312, DG412
• Maytag LDE5914ACL, LDE7304ACE, LDE8506ACE, LDE9304ACE
• Maytag LSE1000, LSE2700W
• Jenn-Air DE412, LSE2704W, LSE7804ACE, LSE7806ACE

If you've got a different model number, double-check the original part numbers (WPY312959, Y312959, AP6024192) in your service manual or on the old belt itself before ordering.