GE & MABE Refrigerator Condenser Fan Motor Parts — Models & Compatibility

Your GE or MABE fridge is running warm, and you've noticed the cooling isn't what it used to be. Before you call a tech, there's a good chance the condenser fan motor has given out — it's one of the most common failures in these models. This hub covers the 294D1233P002 condenser fan motor that fits dozens of GE and MABE refrigerators, plus cross-compatible Frigidaire units.

Is This the Right Part for Your Model?

The 294D1233P002 replaces WR01F04574, 294D1978P001, and WR01F04955. You'll find your model number on a sticker inside the fresh food compartment, usually on the left or right wall. GE models typically start with GTS, HTS, HTR, CTX, or TBX, while MABE models use the FDQC prefix. Cross-reference your full model number against the compatibility list below before ordering.

About This Replacement Part

The condenser fan motor sits behind your fridge near the compressor, pulling air across the condenser coils to dissipate heat. When it fails due to bearing wear or winding damage, the compressor can't cool efficiently — you'll hear either complete silence where the fan should be running, or excessive noise from a struggling motor. Common symptoms include the fridge running too warm, not cooling at all, or noisy operation that wasn't there before. This OEM-quality replacement restores proper airflow and brings temps back to normal. Installation is straightforward: disconnect power, remove the rear access panel, swap the motor with the mounting bracket attached, and reconnect the wire harness. Search for "294D1233P002 installation" on YouTube if you want a visual walkthrough — most techs can swap this in under 30 minutes.

Compatible GE & MABE Models

This condenser fan motor fits the following refrigerator models. If your model isn't listed but your part number matches WR01F04574, 294D1978P001, or WR01F04955, this is your part:

• GTS18FBSARWW (GE)
• GTS18FBRERWW (GE)
• GTS18XCSARWW (GE)
• GTS18GBRERWW (GE)
• HTS18GBSARWW (GE)
• HTR17BBSA (GE)
• CTX18BACGRWW (GE)
• TBX21NICBRWW (GE)
• FDQC18MA5E (MABE)
• FDQC18EL4F (MABE)
• 240369701 (Frigidaire cross-compatible)
• AP4700070 (Frigidaire cross-compatible)
• 5304445861 (Frigidaire cross-compatible)
• 241537301 (Frigidaire cross-compatible)

What Causes Condenser Fan Motor Failure?

Most condenser fan motors fail from simple wear and tear. The bearings dry out after years of constant use, the windings overheat, or dust buildup causes the motor to work harder than designed. In humid climates, moisture can corrode the electrical connections. If you've been hearing grinding or squealing from behind the fridge before it went silent, that was the bearings announcing their retirement. Once the motor stops, your compressor runs hotter and longer trying to compensate, which can lead to compressor failure if you don't replace the fan motor quickly.

Installation Tips

Before you start, unplug the fridge or flip the breaker — never work on live appliances. The condenser fan motor is typically mounted with two or three screws behind the lower rear access panel. Take a photo of the wire connections before you disconnect anything, so you know exactly where each wire goes back. The mounting bracket usually transfers directly from the old motor to the new one. After installation, plug the fridge back in and listen for the fan to start within a few minutes — you should feel airflow at the rear grille. Check the confirmation picture on the product page to verify the connector type matches your existing motor.