GE Refrigerator Condenser Fan Motor Parts — Models & Compatibility

When your GE refrigerator starts making unusual clicking sounds or the fridge compartment feels warmer than it should, the condenser fan motor is often the culprit. This hub covers the WR60X10168 condenser fan motor replacement — a critical component that fits over 100 GE, Hotpoint, Kenmore, and RCA refrigerator models. If you're dealing with a noisy fridge or temperature issues, you're in the right place.

Is This the Right Part for Your Model?

Before ordering, you'll need to verify your exact model number. On most GE refrigerators, you'll find the model number on a sticker inside the fresh food compartment — typically on the upper left or right wall. It'll look something like TBX18SABQRWW or GTS18FBRERWW. Cross-reference your model number with the compatibility list below. This motor replaces several part numbers including AP3855309, WR60X10028, WR60X10153, and PS967022, so if you've found any of those numbers during your research, this is the correct replacement.

About This Replacement Part

The condenser fan motor is mounted near the compressor at the bottom rear of your refrigerator. Its job is to pull air across the condenser coils to dissipate heat — without it running properly, your compressor works overtime and your fridge won't maintain proper temperatures. Common failure symptoms include persistent clicking sounds (the motor trying to start but failing), a fridge compartment that's too warm while the freezer might still work, or the motor not starting at all. The WR60X10168 is a direct OEM-quality replacement designed to restore proper airflow and cooling performance. At $44.99, it's a straightforward fix that can save you from a service call or premature compressor failure.

Compatible GE Refrigerator Models

This condenser fan motor fits a wide range of GE top-freezer and side-by-side models from the TBX, GTS, CTX, and HTR series. Below is a representative sample of compatible models — your specific model may not be listed here, but if it matches the series pattern, it's likely compatible.

Installation Considerations

Replacing the condenser fan motor requires accessing the back lower panel of your refrigerator. You'll need to unplug the unit, remove the rear access panel, disconnect the wire harness, and unbolt the old motor. The new motor mounts in the same location with the same bracket. Most DIYers can complete this repair in under an hour with basic tools. Make sure to clean the condenser coils while you're back there — dirty coils can cause premature motor failure.

Why This Motor Fails

Condenser fan motors typically fail due to dust accumulation, bearing wear, or electrical stress from voltage fluctuations. If your refrigerator is in a garage or basement where dust is more prevalent, the motor works harder and wears out faster. Regular condenser coil cleaning can extend motor life significantly. If you're hearing clicking sounds, that usually means the motor windings are failing and replacement is imminent — don't wait until your fridge completely stops cooling.

Order Your Replacement Motor

The WR60X10168 condenser fan motor is in stock and ready to ship. With proper installation, you'll restore your GE refrigerator's cooling performance and eliminate those annoying noises. Need help identifying your model or have installation questions? Our parts specialists are here to help.