GE Dishwasher Lower Dishrack Roller Parts — Models & Compatibility

Your GE dishwasher's lower rack shouldn't fight you every time you load dishes. If you're hearing grinding noises when sliding the rack in and out, or it's gotten harder to pull the rack forward, worn rollers are typically the culprit. This hub covers the WD12X10136 lower dishrack roller — a small but critical part that fits over 100 GE, Hotpoint, and Kenmore dishwasher models.

Is This the Right Part for Your Model?

Check your dishwasher's model number label — it's usually along the inside edge of the door or on the door frame itself. Cross-reference it with the compatible models list below. This roller fits GE CDW, CDWT, EDWF, GDWF, and GDWT series models, plus select Hotpoint and Kenmore units. If your model starts with CDW9380, CDWT980, EDWF800, GDWF100, or GDWF160, you're in the right place.

About This Replacement Roller

The WD12X10136 is the wheel assembly that allows your lower dishrack to glide smoothly along its track. When these rollers wear down or crack — which happens after years of daily loading cycles — you'll notice the rack catching, sticking, or making scraping sounds. In some cases, damaged rollers can prevent the door from closing properly because the rack sits too high or won't slide back far enough. This part replaces older GE numbers AP3676228, PS958945, and WD12X10107. Each dishwasher typically uses multiple rollers, so inspect all of them when you're diagnosing rack movement issues.

Common Issues This Part Fixes

• Noisy rack operation: Grinding or squeaking when moving the lower rack in and out
• Stuck or difficult-to-move rack: Requires excessive force to pull forward or push back
• Door won't close: Rack sits too high or misaligned, preventing proper door seal
• Poor cleaning results: Misaligned rack affects spray arm coverage

What You'll Need

Replacing these rollers doesn't require any tools in most cases — they typically snap or clip onto the lower rack assembly. Pull the rack completely out of the dishwasher, flip it over, and you'll see the roller assemblies on the corners. Most pop off with firm pressure and snap back into place the same way. Takes about 10 minutes per roller once you've got the rack out.

Compatible Model Numbers

This WD12X10136 roller fits these GE, Hotpoint, RCA, and Kenmore dishwasher models:

• CDW9380N00SS, CDW9380N20SS
• CDWT980R10SS, CDWT980R30SS
• EDWF800P00BB, EDWF800P00WW, EDWF860P00SS
• GDWF100R10BB, GDWF100R10WW, GDWF100R30BB, GDWF100R30WW
• GDWF160R10SS, GDWF160R30SS
• GDWT100R00BB, GDWT100R00WW, GDWT100R10BB, GDWT100R10WW
• GDWT106V00BB, GDWT106V00WW

Plus 90+ additional models. Verify your specific model number before ordering.