Frigidaire Dryer Heating Element Parts — Models & Compatibility

Your Frigidaire dryer's running but clothes come out cold? The heating element restring coil (part 5300622032) is the component that actually generates heat — and when it fails, you're left with damp laundry and a machine that just tumbles air. This hub covers compatible models across Frigidaire, Gibson, Kelvinator, and Westinghouse dryers that use this specific element design.

Is This the Right Part for Your Model?

Check your dryer's model number tag — it's typically inside the door frame or on the back panel. If your model starts with FDE, GDE, KDE, or WDE followed by numbers, you're likely in the right place. This element replaces AP2135127, PS451031, and Q622032, fitting dozens of electric dryer models from the late 1990s through mid-2000s.

About This Replacement Part

The 5300622032 is a restring coil heating element — essentially a tightly wound resistance wire that heats up when electricity flows through it. Unlike one-piece elements, this design allows for replacement of just the coil portion, which sits inside the dryer's heating chamber behind the drum. When these elements fail, it's usually from metal fatigue after thousands of heat cycles, or from lint buildup causing hot spots that weaken the wire. You'll notice the failure immediately: the dryer runs normally but produces zero heat, or it heats intermittently before quitting entirely.

Cross-Brand Compatibility

This element works across multiple brands because Frigidaire manufactured dryers for Gibson, Kelvinator, and Westinghouse during this era. They're mechanically identical machines with different nameplates. If you've got a Gibson GDE dryer or a Kelvinator KDE model from this generation, the same heating element applies — same mounting bracket, same electrical connections, same chamber dimensions.

Compatible Model Series

Below are confirmed compatible models. The FDE series represents Frigidaire's workhorse electric dryers, while GDE covers Gibson-branded units. Most of these are 7.0 cubic foot capacity machines with electronic or mechanical controls.

Installation Considerations

Replacing this element isn't complicated, but it does require pulling the dryer away from the wall and removing panels to access the heating chamber. You'll need to disconnect power first — unplug the machine or flip the breaker. The element sits in a metal housing secured with screws, and you'll need to carefully thread the new coil through the ceramic insulators without bending or kinking the wire. Most folks can handle this in 30-45 minutes if they're methodical about keeping track of screws and wire positions.

Why This Part Fails

Heating elements don't last forever. The repeated expansion and contraction from heating cycles eventually weakens the resistance wire. Lint buildup accelerates failure — if lint gets into the heating chamber and wraps around the coil, it creates insulation that causes localized overheating. That's why cleaning your dryer vent regularly actually extends element life. Power surges can also blow elements instantly, though that's less common than simple wear-out.

Verifying Your Part Number

If you're replacing an existing failed element, compare the part number stamped on the metal bracket or tag. You're looking for 5300622032, or the older numbers it replaces: AP2135127, PS451031, or Q622032. They're all the same physical part with different supplier codes. If your current element has a completely different number format, double-check your model number — you might have a different heating system design.