Free Shipping $49+
Factory Direct No Middleman
30-Day Returns
24/7 1-800-HEIMA-00
Clears F10 runaway temperature fault codes triggered by a failed or shorted sensor sending incorrect readings to the control board.
Resolves oven that exceeds the set temperature and keeps heating, a common symptom of a sensor reading much lower than actual oven temperature.
Fixes oven that under-heats or won't bake to the programmed temperature because the sensor is reading falsely high resistance.
Restores consistent heat distribution when inaccurate sensor feedback causes the control board to cycle heating elements incorrectly.
Addresses intermittent oven shutoff during cooking cycles caused by the sensor sending erratic temperature signals to the electronic control board.
💡 Pro Tip: How to Diagnose a Faulty Oven Temperature Sensor
Your part is likely the culprit if you notice any of the following:
⚠️ Oven displays F10 error code (runaway temperature fault)
⚠️ Oven overheats significantly beyond the set temperature
⚠️ Oven won't reach or maintain the set cooking temperature
⚠️ Baking/roasting results are inconsistent or unevenly cooked
🔬 Quick Test: Remove the sensor and measure resistance between the two connector prongs with a multimeter. A healthy sensor reads approximately 1080–1090 ohms at room temperature. A reading far below (e.g., 85 ohms) or above 1200 ohms confirms sensor failure and the need for immediate replacement.
📦 What's in the Box
✅ 1× Oven Temperature Sensor Probe (approx. 8 inches, 2-wire RTD probe, compatible with 316490000)
We typically respond within 1 business day. Include your appliance model number for the fastest answer.
Disclaimer: Compatibility information, part numbers, and model fitment data on this page are sourced from manufacturer databases and third-party references. While we strive for accuracy, please verify your appliance model number before ordering. Heima is not responsible for errors or omissions in compatibility listings.
Reviews
There are no reviews yet.