Frigidaire Refrigerator Wire Shelf Parts — Models & Compatibility

If you're replacing a bent, rusted, or broken wire shelf in your Frigidaire top-freezer refrigerator, this hub covers the 240360908 replacement shelf and which models it fits. This genuine OEM-compatible shelf works across multiple Frigidaire series from 2010-2018, including FFHT and FFTR models. Most owners replace these shelves after years of heavy use cause the wire coating to crack or the shelf frame to warp under weight.

Is This the Right Shelf for Your Model?

Check your refrigerator's model number — it's usually on a sticker inside the fresh food compartment on the left or right wall, near the top. You're looking for model numbers starting with FFHT18, FFTR18, FFHT17, or FFTR17. This shelf specifically fits 18 cubic foot and some 17 cubic foot Frigidaire top-freezer models manufactured between 2010-2018.

The 240360908 shelf replaces older part numbers 240360905, 240360901, 3189137, and AP5805565. If your original shelf has any of those numbers stamped on the plastic end caps, this is your replacement.

About This Replacement Shelf

This is a full-width wire shelf that spans the entire refrigerator interior — typically 28-30 inches wide depending on your model. It features vinyl-coated steel wire construction with snap-in plastic end caps that lock into the refrigerator's side rails. The shelf supports up to 50 pounds when weight is evenly distributed.

Most people replace these shelves when the vinyl coating cracks and exposes bare wire (which can rust), or when the shelf frame becomes permanently bent from overloading. You'll know it's time when items no longer sit level, or you see orange rust spots forming on the wire. The plastic end caps can also crack over time, causing the shelf to pop out of the side rails unexpectedly.

Installation Overview

Installing this shelf takes about two minutes. Remove everything from the old shelf, then lift the front edge up and pull forward to disengage the rear hooks from the refrigerator wall. The shelf slides right out. For the new shelf, angle it slightly and insert the rear hooks first, then lower the front edge until the plastic end caps snap into the side rail slots. You'll hear a distinct click when it's properly seated.

No tools needed — it's a straightforward snap-in replacement. Just make sure the shelf is level before loading it up with food.

Compatible Frigidaire Models

This wire shelf fits the following Frigidaire refrigerator models. If your model isn't listed but starts with FFHT18, FFTR18, FFHT17, or FFTR17, check the model number sticker inside your refrigerator — there's a good chance it's compatible:

• FFHT1814LB0, FFHT1814LB1, FFHT1814LB2, FFHT1814LB3
• FFHT1814LW0, FFHT1814LW1, FFHT1814LW2
• FFHT1814LM0
• FFHT1715LB5
• FFTR1814LB0, FFTR1814LB1, FFTR1814LB2, FFTR1814LB3
• FFTR1814LW0, FFTR1814LW1, FFTR1814LW2, FFTR1814LW3
• FFTR1814LM0, FFTR1814LM1
• FFTR1715LW0, FFTR1715LB0

This list represents the most common models. The part also fits select Electrolux and Kenmore models that share the same cabinet design as these Frigidaire units.

Ordering Information

The 240360908 shelf is priced at $70.99 and ships ready to install. You're getting the complete shelf assembly — wire frame with both plastic end caps pre-installed. Some suppliers sell just the wire frame without end caps, so verify you're getting the complete assembly before ordering.

If you need multiple shelves or are replacing other interior parts at the same time, check compatibility for door bins and crisper drawers — many Frigidaire models from this era share the same interior components across different series.