Samsung & Kenmore Dryer Thermal Fuse Parts — Models & Compatibility

Your Samsung dryer suddenly won't heat, or maybe it won't start at all — that's the thermal fuse doing its job. When your dryer overheats (usually from a clogged vent), this tiny safety device cuts power to prevent fires. The DC47-00016A thermal fuse is the direct replacement for over 100 Samsung and Kenmore dryer models, and it's one of the most common repair parts you'll need.

Is This the Right Part for Your Model?

Check your dryer's model number — it's on a sticker inside the door frame or on the back panel near the power cord. Match it against the compatibility list below. This fuse works across Samsung's DV and DVE series, plus Kenmore 110-series dryers manufactured by Samsung. If your model starts with DV, DVE, or DVG, you're likely in the right place.

About This Replacement Part

The DC47-00016A is a one-time-use thermal fuse rated at 250°F. Once it blows, you can't reset it — replacement is the only option. When this fuse fails, your dryer exhibits two classic symptoms: it won't heat (the drum spins but no warmth), or it won't start at all (completely dead, no lights or sounds). Both scenarios point to the same culprit. Samsung positioned this fuse on the blower housing or heating element assembly, depending on your model year. It's a critical safety component that prevents lint buildup from causing dryer fires, so if yours blew, clean your vent thoroughly before installing the new fuse. Otherwise, you'll be replacing it again in a few months.

Common Failure Pattern

Most DC47-00016A fuses blow because of restricted airflow. Your dryer's trying to heat, but the hot air can't escape through a clogged vent, so temperatures spike past the fuse's 250°F threshold. You'll notice longer dry times in the weeks before failure — that's your warning sign. Check the outdoor vent hood, the flexible transition duct behind the dryer, and the internal blower wheel for lint accumulation. If you skip this step and just replace the fuse, you're treating the symptom, not the problem.

Installation Overview

You'll need to access the blower housing by removing the front or rear panel, depending on your Samsung model. The fuse connects with two push-on terminals — no soldering required. Disconnect power first (unplug it, don't just turn it off), then remove the old fuse and press the new one into the same bracket. Most repairs take 30-45 minutes if you've got basic tools and a YouTube video for your specific model. Test continuity on the old fuse with a multimeter — if it reads infinite resistance, it's definitely blown.

Cross-Reference Numbers

This part replaces Samsung DC47-00016A, AP4201894, PS4205213, and 2068545. If you've got an old work order or repair estimate listing any of those numbers, they're all the same fuse. Kenmore branded it differently for their badge-engineered models, but the physical part is identical.