Hotpoint Ariston Indesit Drain Pump Filter Kit Parts — Models & Compatibility

If you own a Hotpoint, Ariston, or Indesit washer or washer-dryer combo, you've probably dealt with drainage issues at some point. This C00141034 drain pump filter kit fits dozens of models across these three brands — plus some Whirlpool units — and addresses the most common cause of standing water in your drum. This hub covers which models need this specific kit and how to verify you're ordering the right part.

Is This the Right Part for Your Model?

The C00141034 fits a wide range of Hotpoint AQ and WD series washers, Ariston AQ models, and Indesit washer-dryers. Your model number is typically on a sticker inside the door rim or on the back panel near the water inlet. Match your exact model against our compatibility list below — these European-designed machines often share the same pump housing, which is why one filter kit works across multiple brands.

About This Replacement Part

The C00141034 drain pump filter kit includes the filter housing and seals needed to maintain proper drainage in front-load washers and washer-dryer combos. This part (also sold as 482000022946 141034) is essential when you're experiencing slow drainage, water pooling in the drum after cycles, or error codes related to pump function. Hotpoint's AQGMD and BHWD series, along with Ariston's AQ113D models, use this same filter design — it's the component that catches lint, coins, and small objects before they damage the pump impeller. If your machine won't drain or you're getting standing water after the spin cycle, a clogged or damaged filter is usually the culprit.

Why This Filter Fails

The filter housing cracks over time from thermal stress — these combos run hot wash and dry cycles back-to-back, which causes plastic to become brittle. Small objects wedged in the filter threads can also crack the housing when you try to unscrew it for cleaning. Once the seal fails, you'll see water leaking from the front lower panel during drain cycles. The rubber gasket deteriorates faster if you use high-temperature washes frequently or if detergent buildup isn't cleaned regularly.

Compatible Model Series

This kit works across several major product lines. The Hotpoint AQGMD series (including AQGMD129UK and AQGMD149UK) uses this filter exclusively. The BHWD washer-dryer combos (BHWD129UK, BHWD149UK) share the same pump assembly. Hotpoint's IWDE integrated models (IWDE126UK, IWDE146UK) also require this part. The XWDA and XWDE series — like XWDA751680XW and XWDE861480XW — all use this same filter design. Ariston's AQ113D models (AQ113D697IUK, AQ113D697SUK) and AQ113F units need this kit as well.

Installation Considerations

You'll need to access the lower front panel to reach the filter housing. Most Hotpoint and Ariston models have a kickplate that pops off — some have clips, others use screws hidden behind rubber plugs. Keep a shallow pan and towels ready because residual water will pour out when you unscrew the old filter. The new kit includes replacement O-rings — don't reuse the old seals even if they look intact. Hand-tighten only; overtightening cracks the housing threads.

Verify Your Model Number

Before ordering, confirm your exact model number matches our list. The C00141034 fits specific pump configurations — using the wrong filter kit means it won't seal properly or won't thread into your pump housing. If your model number starts with AQ, BHWD, IWDE, XWDA, or XWDE, you're likely in the right place, but always cross-reference the complete model code.