LG & Kenmore Washer Circulation Pump Motor Parts — Models & Compatibility

Your LG or Kenmore front-load washer won't drain, and there's water sitting in the drum after a cycle. That's the telltale sign of a failed circulation pump motor — the component that moves water through the wash system and out during drain cycles. This hub covers the EAU61383501 pump motor, which fits over 50 LG and Kenmore front-load washer models from the WM and 796.4 series.

Is This the Right Part for Your Model?

Before ordering, you'll need to confirm your exact model number. On LG front-loaders, check inside the door frame (usually on the right side near the hinge) or on the back panel near the water inlet connections. Kenmore models typically have the tag on the left side of the door opening. The EAU61383501 replaces older part numbers including EAU61383503, 4681EA2001C, EAU62263303, and AP5620091 — so if you're cross-referencing from an old service manual, any of these numbers confirm compatibility.

About This Replacement Pump Motor

The circulation pump motor serves double duty in LG's direct-drive washer design. It recirculates water during wash cycles for better cleaning performance, then switches to drain mode to remove water at cycle end. When it fails, you'll notice water pooling in the drum — the washer completes the cycle but leaves standing water behind. Sometimes you'll hear a humming noise as the motor tries to engage but can't spin the impeller. This part is the actual motor assembly that drives the pump impeller, and it's a common failure point after 5-7 years of regular use, especially in homes with hard water that can cause mineral buildup on the motor shaft.

Compatible Model Series

This pump motor fits LG's premium front-load washer lineup and their Kenmore-branded equivalents. The WM3000-WM9000 series represents LG's largest capacity washers with TurboWash and steam features, while the 796.4 series covers Kenmore Elite models built on the same platform. If your model starts with WM followed by four digits, or 796.4 for Kenmore, there's a strong chance this is your part.

Verified Compatible Models

This motor assembly has been verified to fit the following LG and Kenmore washer models:

• WM3997HWA — 1 compatible part
• WM9000HVA — 1 compatible part
• WM9000HWA — 1 compatible part
• WM8000HVA — 1 compatible part
• WM8000HWA — 1 compatible part
• WM8100HVA — 1 compatible part
• WM8100HWA — 1 compatible part
• WM5000HVA — 1 compatible part
• WM5000HWA — 1 compatible part
• WM4370HWA — 1 compatible part
• WM4270HVA — 1 compatible part
• WM4270HWA — 1 compatible part
• WM3988HWA — 1 compatible part
• WM3770HVA — 1 compatible part
• WM3770HWA — 1 compatible part
• WM3677HW — 1 compatible part
• WM3670HVA — 1 compatible part
• WM3670HWA — 1 compatible part
• WM3570HWA — 1 compatible part
• WM3488HW — 1 compatible part

What You're Getting

The EAU61383501 is the complete motor assembly that mounts to the pump housing. It includes the motor body, electrical connections, and mounting bracket. You're not getting the entire pump — just the motor that drives it. If your pump housing or impeller is cracked or damaged, you'll need additional parts. But if your washer's just not draining and you hear that telltale hum, this motor replacement typically solves the problem.