Whirlpool & Maytag Washer Suspension Rod Parts — Models & Compatibility

Your Whirlpool or Maytag top-load washer walking across the laundry room floor during spin cycle? That violent shaking isn't just annoying—it's a sign your suspension rods have failed. This hub covers the W10440786 suspension rod kit that fits dozens of WTW and Maytag Bravos series washers, the machines most prone to this exact problem.

Is This the Right Part for Your Model?

Check your washer's model number—it's on a sticker inside the washer lid or on the back panel near the top. You need all four suspension rods (this kit includes them) if your machine is shaking during spin or making loud banging noises. The W10440786 replaces older part numbers W10368626, W10368627, and W10440739, so if you've got any of those listed in your manual, this is your part.

About This Replacement Part

Suspension rods are what keep your wash basket stable during high-speed spins—they're essentially heavy-duty shock absorbers. When they wear out (usually after 5-8 years), the basket loses stability and starts banging against the cabinet. The two main symptoms you'll see: the washer physically moving across the floor during spin, and violent shaking that sounds like the machine's tearing itself apart. This isn't something you can ignore—continued operation with bad suspension rods can damage the cabinet, crack the outer tub, or even break the drive system. The W10440786 kit gives you all four rods you need for a complete repair.

Compatible Whirlpool & Maytag Models

This suspension rod kit works across Whirlpool's WTW series and many Maytag Bravos models. Here are the most common machines that use this part:

• WTW8200YW0 — Whirlpool Cabrio
• WTW8240YW0 — Whirlpool Cabrio Platinum
• WTW8500BC0, WTW8500BR0, WTW8500BW0 — Whirlpool High Efficiency
• WTW8540BC0, WTW8540BC1, WTW8540BW0, WTW8540BW1 — Whirlpool Cabrio
• WTW8600YW0, WTW8600YW1 — Whirlpool Cabrio
• WTW8800YC0, WTW8800YC1 — Whirlpool Cabrio

Most WTW models from 2010-2016 use this same suspension system. If your model starts with WTW and you're seeing the shaking symptom, there's a 90% chance this is your part.

Why This Part Fails

Suspension rods take a beating—they're absorbing the force of a 20-30 pound load of wet clothes spinning at 1000+ RPM. Over time, the internal springs weaken and the rubber bushings deteriorate. Heavy loads and unbalanced spins accelerate the wear. Once one rod fails, the others aren't far behind because the stress redistributes unevenly. That's why you replace all four at once, even if only one looks obviously bad.

What You'll Need for Installation

You'll need a socket set (likely 7/16" or 1/2" sockets), and it helps to have a second person—the wash basket needs to be lifted slightly to relieve tension on the rods during removal. Budget about an hour for the job if you're comfortable with basic repairs. The hardest part is maneuvering the cabinet off and dealing with tight clearances around the suspension mounts.

Order Your Suspension Rod Kit

The W10440786 suspension rod kit is priced at $73.99 and includes all four rods needed for a complete repair. That's significantly less than a service call, and these aren't difficult to install if you're reasonably handy. If your washer's shaking itself across the floor, don't wait—continuing to run it will cause expensive secondary damage.