Samsung & Kenmore Washer Center Tub Oil Seal Parts — Models & Compatibility

Water pooling under your Samsung or Kenmore washer? That center tub oil seal (DC62-00223A) might be the culprit. This seal sits between the outer tub and transmission, and when it fails, you'll see water leaking from underneath during spin cycles. This hub covers the genuine replacement seal that fits Samsung 592-series washers and Kenmore 40249032xxx models.

Is This the Right Part for Your Model?

The DC62-00223A seal works across both Samsung and Kenmore front-load washers manufactured between 2008-2015. Your model number is stamped on a metal plate — on Samsung models, check inside the door rim or on the back panel near the water inlet. For Kenmore units, it's typically on the front frame behind the door. You're looking for model numbers starting with 592-49xxx (Samsung) or 40249032xxx (Kenmore).

About This Replacement Seal

The center tub oil seal prevents water from entering the bearing housing during wash and spin cycles. When this seal deteriorates — usually from detergent buildup or normal wear after 8-10 years — water migrates into the bearing area, causing that telltale grinding noise and rust stains on clothes. This is a critical repair because a failed seal leads to bearing failure within months if left unchecked. The DC62-00223A replaces Samsung part numbers AP4211943 and PS4208713, ensuring you get the exact factory-spec seal without compatibility guesswork.

Installation Overview

Replacing this seal requires disassembling the washer cabinet and removing the drum assembly to access the tub seal location. Unplug the appliance before starting — this isn't optional. Wear work gloves throughout the repair since you'll be handling sharp metal edges and heavy components. Most DIYers budget 2-3 hours for this repair, though it's considered an advanced fix because you're working deep inside the machine.

Compatible Samsung & Kenmore Models

This DC62-00223A seal fits the following washer models. Verify your exact model number matches before ordering:

• Samsung 592-49032 — Front-load washer series
• Samsung 592-49042 — Front-load washer series
• Samsung 592-49045 — Front-load washer series
• Samsung 592-49052 — Front-load washer series
• Samsung 592-49075 — Front-load washer series
• Samsung 592-49082 — Front-load washer series
• Samsung 592-49087 — Front-load washer series
• Samsung 592-49127 — Front-load washer series
• Samsung 592-49145 — Front-load washer series
• Samsung 592-49147 — Front-load washer series
• Samsung 592-49155 — Front-load washer series
• Kenmore 40249032010 — Front-load washer
• Kenmore 40249032011 — Front-load washer
• Kenmore 40249032012 — Front-load washer

Why This Seal Fails

Samsung front-loaders run at high spin speeds — up to 1300 RPM — which puts constant pressure on the tub seal. Over time, laundry detergent residue hardens around the seal, creating micro-channels where water seeps through. Once water reaches the bearings, rust forms quickly. You might notice a brown residue on clothes or hear a grinding sound that gets louder during the spin cycle. That's your warning sign that the seal has already failed and bearing damage is starting.

Order Your Replacement Seal

The DC62-00223A is priced at $38.99 and ships directly from our warehouse. It's the same OEM seal Samsung techs install, not an aftermarket substitute. If you're already hearing bearing noise, you'll likely need both the seal and the bearing assembly — but start by inspecting the seal first since it's the component that fails initially and causes secondary damage.