LG Dryer Drum Support Roller & Axle Parts — Models & Compatibility

If your LG dryer sounds like it's grinding gravel or the drum won't spin smoothly, you're likely dealing with worn drum support rollers. This hub covers the 4581EL2002C replacement roller and axle assembly — the part that keeps your drum rotating freely on models from the DLE and DLEX series. We've mapped out compatibility across 100+ LG and Kenmore-branded LG dryers so you can verify your model quickly.

Is This the Right Part for Your Model?

Check your dryer's model number first — you'll find it on a metal tag inside the door opening or on the back panel. Cross-reference it against the compatibility list below. This roller assembly (which replaces older part numbers 4581EL2002A and 4581EL2002B) fits most LG electric dryers manufactured between 2005 and 2015, including DLE, DLEX, and corresponding Kenmore 796-series models.

About This Replacement Part

The drum support roller is what allows your dryer's drum to rotate smoothly. Each roller sits on a metal axle and supports thousands of pounds of rotating weight over its lifetime. When these wear out — typically after 8-12 years of use — you'll hear loud thumping, squealing, or grinding noises during the drying cycle. In severe cases, the drum won't spin at all because the worn rollers create too much friction. This assembly includes both the roller wheel and the axle shaft, so you're replacing the entire support mechanism in one go. Most techs replace all the drum rollers at once since if one has failed, the others aren't far behind.

Common Symptoms

Your dryer will tell you when the drum rollers need replacement. The most obvious sign is noise — a rhythmic thumping that speeds up as the drum accelerates, or a constant grinding sound that doesn't stop. Some dryers develop a squealing noise that changes pitch during the cycle. In the worst cases, the drum won't turn at all because the worn rollers have seized or flattened, creating too much resistance for the motor to overcome. If you open the dryer door and manually spin the drum, you might feel it wobble or catch at certain points instead of spinning freely.

Replacement Parts Available

The 4581EL2002C is the current replacement for this drum support system. It supersedes earlier versions (4581EL2002A and 4581EL2002B) and cross-references to AP5688895 and PS8260240 in parts databases. This assembly comes as a complete unit with the roller already mounted on the axle shaft, ready to install. You'll typically need to replace the rollers in pairs or sets of four depending on your dryer model's design — check your service manual or the drum support configuration before ordering.

Installation Overview

Replacing drum support rollers requires disassembling the dryer cabinet to access the drum. You'll need to remove the front or top panel, disconnect the drum belt, and lift out the drum to reach the roller mounts at the rear of the cabinet. The old rollers slide off their mounting brackets once you remove the retaining clips or tri-ring fasteners. Installing the new rollers is straightforward — they press onto the shafts and lock in place. The tricky part is reassembling everything and properly tensioning the drum belt. Budget 45-90 minutes if you're comfortable with appliance repair, longer if it's your first time.

Compatible LG Dryer Models

This drum roller assembly works with over 100 LG and Kenmore-branded LG dryer models. Below is a representative list of confirmed compatible models — if yours isn't listed but shares the same series designation (DLE, DLEX, DLGX), it likely uses this same roller assembly.