LG Dishwasher Mounting Bracket Kit Parts — Models & Compatibility

If your LG dishwasher is sagging, tilting forward when you open the door, or pulling away from the countertop, you're dealing with a mounting bracket failure. The 5001DD4001A kit is the factory replacement for LDF series dishwashers — it includes everything needed to secure your unit properly to the cabinet.

Is This the Right Part for Your Model?

This mounting bracket kit fits LG dishwashers in the LDF6810, LDF6920, LDF7810, LDF7811, LDF7920, LDF7932, LDF8812, LDF8922, LDF9810, and LDF9932 series. Your model number is located on the left door edge (open the door and look at the side frame) or on the top edge of the door when opened. Match your complete model number against the compatibility list below — the letter suffix matters (BB for black, ST for stainless, WW for white, TB for textured black).

About This Replacement Part

Factory LG mounting brackets hold your dishwasher flush against the underside of your countertop. Over time, vibration from wash cycles loosens screws, or the brackets themselves crack from the weight of a loaded dish rack. When this happens, the entire unit can tilt forward dangerously when you pull out the bottom rack. This kit includes both left and right mounting brackets with the correct hardware. It's the same part LG techs use for warranty repairs, and it directly replaces part numbers AP4438292, PS3525525, AH3525525, 1266844, and EA3525525.

Compatible LG Dishwasher Models

This mounting bracket kit works with the following LG dishwasher models:

• LDF6810BB
• LDF6810ST
• LDF6810WW
• LDF6920BB
• LDF6920ST
• LDF6920WW
• LDF7810BB
• LDF7810ST
• LDF7810WW
• LDF7811BB
• LDF7811ST
• LDF7811WW
• LDF7932BB
• LDF7932ST
• LDF7932WW
• LDF7920BB
• LDF7920ST
• LDF7920WW
• LDF8812ST
• LDF8922ST

Why You Need This Part

A loose or broken mounting bracket isn't just annoying — it's a safety issue. When your dishwasher isn't secured to the cabinet, opening the door with a full bottom rack can cause the entire unit to tip forward. This puts stress on the water supply line and drain hose connections, potentially causing leaks. The forward tilt also misaligns the door seal, which can lead to water escaping onto your floor during cycles.

What's Included

The 5001DD4001A kit contains both left and right mounting brackets, mounting screws, and installation instructions. You'll need a Phillips screwdriver and about 20 minutes. Pull the dishwasher forward slightly to access the old brackets from above, remove the worn hardware, position the new brackets against the underside of your countertop, and secure them through the existing screw holes in the dishwasher's top frame.