GE Refrigerator LED Light Board Assembly Parts — Models & Compatibility

If your GE or Hotpoint refrigerator's interior lighting stopped working or only some LEDs illuminate, the WR55X26671 LED Light Board Assembly is likely what you need. This hub covers the compatibility for this specific board across GE's DSE, GSE, and GSS series refrigerators — the models most commonly affected by LED board failures.

Is This the Right Part for Your Model?

Check your refrigerator's model number label, typically located inside the fresh food compartment on the upper left or right wall. The model number starts with letters like DSE25, GSE25, GSE23, or GSS23. This LED board assembly (part number WR55X26671) replaces older part numbers AP6035586, PS11767930, 4468532, and EAP11767930, so if you're cross-referencing from an older service manual, these are all the same part.

About This Replacement Part

The WR55X26671 LED Light Board Assembly is the main lighting module for GE's side-by-side and French door refrigerators manufactured in the 2015-2020 period. This board controls all interior LED lighting for the fresh food compartment. Unlike older incandescent bulb systems, when this board fails, you can't just swap a bulb — the entire assembly needs replacement. The board includes surface-mounted LEDs soldered directly to the circuit, along with the driver circuitry that regulates voltage. Common failure modes include complete lighting loss, flickering when the door opens, or partial illumination where only half the LEDs work. The board mounts to the interior ceiling of the refrigerator compartment and connects via a plug-in harness.

Compatible Model Series

This LED board fits across three main GE refrigerator series: the DSE25 (side-by-side models), GSE25 and GSE23 (French door configurations), and GSS23 (side-by-side with through-the-door ice). All compatible models share the same mounting bracket design and electrical connector. If your model number matches the patterns below, this is your correct replacement part.

Pricing & Availability

The WR55X26671 LED Light Board Assembly is priced at $85.99. While it's not the cheapest refrigerator part, it's significantly less expensive than an authorized service call, which typically starts around $200 before parts. The board is a genuine OEM-equivalent component designed to match GE's original specifications.

Installation Overview

Replacing this LED board requires disconnecting power to the refrigerator, removing the light cover panel inside the fresh food compartment, unplugging the old board's wire harness, and mounting the new assembly. You'll need a Phillips screwdriver and about 20 minutes. The job is straightforward — no refrigerant work, no compressor access, just basic electrical connector work.