Frigidaire Washer Door Strike Parts — Models & Compatibility

Your Frigidaire washer won't start because the door won't latch properly — you push it closed, hear a click, but the cycle never begins. This door strike (part 131763310) is the metal catch on the washer frame that the door lock hooks into, and when it wears out or breaks, your washer thinks the door is open even when it's not. This hub covers the replacement door strike for over 600 Frigidaire, Kenmore, Crosley, Gibson, Westinghouse, and Electrolux front-load washer models.

Is This the Right Part for Your Model?

Check your washer's model number — it's typically on a sticker inside the door rim or on the front panel behind the dispenser drawer. This strike fits the ATF, ATFB, FAFW, GLTF, and FTF series models manufactured between 2005-2015. If you're seeing error codes related to door lock failure or the washer fills but won't agitate, this strike is likely your culprit.

About This Replacement Part

The door strike is a simple metal bracket that mounts to the washer's front panel. Over time, the repeated stress of door closures causes the strike to crack or bend, especially around the mounting holes. When this happens, the door lock can't engage properly — you'll push the door closed and it either bounces back open or seems closed but the control board never gets the signal to start. Most users report seeing "door ajar" error codes or the washer simply refusing to fill with water because it thinks the door isn't secure. The good news? This is one of the easiest washer repairs you'll do — no special tools needed beyond a screwdriver, and most people have it swapped in under 15 minutes.

Common Failure Symptoms

• Door won't stay latched: You close it, but it pops back open immediately
• Washer won't start: Control panel lights up, but pressing Start does nothing
• Won't fill with water: Cycle selector works, but no water enters the drum
• Door lock clicks but cycle won't begin: You hear the lock engage, but the wash cycle never starts

Installation Overview

Unplug the washer first — always. Open the door and locate the two screws holding the strike to the front panel (usually T20 Torx or Phillips head). Remove the old strike, position the new one so the holes line up, and secure it with the screws. Test the door closure a few times before running a cycle. The entire job takes less time than a regular wash cycle.

This Part Replaces

AP3580441, PS890617, 131763300, 1032664

Fits These Model Series

• ATF6000 Series (ES0, ES1, FS0, FS1, FS2)
• ATFB6000 Series (ES0, ES1)
• FAFW Series (3511KW0, 3801LW0, 4011LW0)
• GLTF2940 Series
• FTF2140 Series

Compatible Models

ATF6000ES0, ATF6000ES1, ATF6000FS0, ATF6000FS1, ATF6000FS2, ATFB6000ES0, ATFB6000ES1, FAFW3511KW0, FAFW3801LW0, FAFW4011LW0, GLTF2940FS1, FTF2140FS2, and over 600 additional models across Frigidaire, Kenmore, Crosley, Gibson, Westinghouse, and Electrolux brands.